Question about Ford Cars & Trucks

Open Question

Looking for the initialization procedure for the Vista roof on a 2007 Ford Edge.

Posted by on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try and if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Jan 12, 2010



Doubt it failed----did you test it with a volt meter,put
an oscilloscope on it,or look at scan tool data

Have a couple T20 Torx Screws that hold it on

You heat them with a hair dryer to soften the
Blue Thread Locker

Why not tell us the vehicles problems & what you tested so far

Posted on Aug 31, 2012

  • 2101 Answers

SOURCE: How can I reset my computer on my ford edge so I

that should be a relay

Posted on Dec 02, 2012

  • 483 Answers

SOURCE: how to tune up 2007 ford edge

with electronic and computer controled ignition, replacing the spark plugs is about it

Posted on Mar 10, 2013

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

How can I reset the anti theft lock system on my 2007 ford edge

Probably looking at a visit to the local Ford dealer.

Feb 18, 2015 | 2007 Ford Edge SEL Plus


Ford Edge vista roof maintence and cleaning

Part one to the removal, cleaning and maintenance of the Ford Edge vista roof all model years
Ford Edge Panoramic Vista Roof Maintenance Part 1

on Aug 25, 2016 | Ford Edge Cars & Trucks


Ford Edge Vista roof maintenance

This is part two of the vista roof maintenance, cleaning, re-installation and the Intitialization process along with timed results for the evidence to prove the cleaning worked.
Ford Edge Panoramic Vista Roof Maintenance Part 2

on Aug 25, 2016 | Ford Cars & Trucks

1 Answer

Problems with my vista roof how can i closed it


I'm sorry but I believe you have this posted in the wrong product category? Please re-post the question in the proper category if this is the case, otherwise you have my apologies. This is the car and truck problem category

Jul 09, 2012 | 2007 Ford Edge SEL Plus


Ford Edge Vista roof cleaning and maintenance

This is part one to the removal, cleaning, maintenance of slides, re-installation and re-intitialization of the Vista roof on a Ford Edge all model years.

on Aug 25, 2016 | Ford Cars & Trucks

1 Answer

I have had my 2007 Ford Edge SEL Plus into the dealer 3 times because of my stereo system. It seems to fade in and out and not get the best reception. They have done everything from replace my speakers...

I work for ford and haven't seen this particular problem on any edges before. Once on a focus and no one could figure it out. It was the exact problem you just described. Turned out to be a loose antenna wire where it plugs into the antenna mast on the roof. Check to see if your roof antenna moves at all when you grab it, it should be tight. Even give it a few light smacks from the inside of the vehicle and see if you notice anything through the speakers. If none of this helps let me know I would like to help you out some more if needed. I would also like to know if this helps you never know I might just see this problem roll into the shop one day.

Jan 26, 2011 | 2007 Ford Edge SEL Plus

1 Answer

I was involved in a accident this past week in my a 2007 Ford Edge that I just bought 5 days earlier. My husband hit a deer and the air bag light is on but no air bag deployed. Why is this and can it be...

The impact probably initiated a sensor on the front of the vehicle. Find a shop that deals with airbags and have them check all the sensors' status. Most likely you will need to replace the front two.

Nov 20, 2009 | 2007 Ford Edge SEL Plus

1 Answer

I need to change the bulbs in the over head panel and can not remove it

the lamp covers usually pop off. Look for a slot to insert a screwdriver.

96 taurus

Roof Console-Mounted
Removal and Installation

  1. Insert flat screwdriver tip into notch at forward edge of roof console (519A58).
  1. Push screwdriver rearward, compressing retaining clip. Pull forward edge of roof console down away from headliner.
  1. Disconnect electrical connector by depressing square locking tab and pulling connector end out of roof console.
  1. Removeroof console.
  1. To install, reverse Removal procedure.


Jun 20, 2009 | 1991 Ford Taurus

1 Answer

Front-end clunk

bottom ball joints worn

May 30, 2009 | 2007 Ford Edge SEL Plus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides