Question about Opel Omega

Open Question

Looking for opel/vauxhall omega vaucume lines for the heater control 1994-1998 locations for rear vents location.

Rear heat control console to allow heat to the rear of the vehicle back seats, under the drivers and passengers seats and the center console omega vauxhall/opel omega 1994 to 1998

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 1998 buick park avenue drivers side blows cold, passenger side hot

sounds like the drivers temp door actuator is not working should be located on the drivers side of the air box down by the gas pedal or center dash area.

Posted on Nov 06, 2008

  • 491 Answers

SOURCE: 2005 Chevy Impala driver's side heat blows cold.

First....buy a drivers side air flow actuator at a auto parts place for dual zone heating/cooling.
(NAPA etc will have it.....or the dealer)
Open the glove compartment.....all the way....you may have to take the screws out at the bottom......look in at the heater assembly....look over to the left....you will see the two air flow actuators.
Look at the part you have and match it to the part on the heater assembly.
The actuator that is closest to the engine is the drivers side control.
Replace it.
Try your controls and check for heat and cooling on both sides.
The stepper motor in these actuators goes bad on quite a few...but over look that.....you have a great car,good for many miles of trouble free driving.


Posted on Nov 03, 2009

  • 14 Answers

SOURCE: FRONT HEATED SEATS

you need to check the resistance in each of the heated seat elements in the seat. There's a two wire connector under the back of each front seat. The connector should be green. disconnect it and measure the resistance along the circuit going into the seat. if it isnt .1 - .3 ohms, replace the appropriate heated seat element

Posted on Jan 06, 2010

  • 1 Answer

SOURCE: where is fuse for drivers side heated seat on 2006 Buick Terraza

i have a 2005 terraza and the fuse panel is at the end of the dash board on the passengers side .there is a finger slot in a plastic cover,pull to remove. fuse panel is behind .i had to call a service tech to find mine. good luck pete.

Posted on Jul 26, 2010

jturcotte
  • 7716 Answers

SOURCE: Cannot locate where the fuse

Hi, that fuse is in the box under the hood. See pic below. I think it's fuse 32. Fuse 45 also powers those outlets but also power a lot of other circuits. The fuse for the outlet in the very back of the car is on the interior fuse panel, #14. All of this information is in your owners manual. You can download the manual here: http://www.extendedgmwarranty.com/owners-manual/buick/2002-Buick-Rendezvous.pdf

jturcotte_19.png

Posted on Jun 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a vauxhall omega cd 2.2 with a fault code p1070 map sensor issue, does anyone know where this map sensor is located please ?


The dreaded opel 4 cyl inline ,most of my problems with this range of vehicles is caused by the fact that the computer is bolted to the inlet manifold and suffers from overheating which causes all mannor of code faults and often the immobilisor.Right mass air flow is in the pipe from the air filter to the inlet manifold

Jan 17, 2015 | Vauxhall Cars & Trucks

1 Answer

Heater matrix problem vauxhall Omega 95


the heater core perhaps needs to be replaced.

Mar 13, 2014 | Vauxhall Cars & Trucks

1 Answer

Passenger side heat doesn't work in my 2007 Dodge Grand Caravan. There is no heat, only cold air, coming from the dash, floor, & defrost vents. There are dual temp controls for the driver &...


I really can't be sure off hand, but what you wrote looks like the control valves are sticking(these flaps allow air to go different directions at the vents). its located at the heater core(towards the left side of the heater core) under the plastic just under the dash. you can manually move them, encase they are stuck, they do stick sometimes. while checking the vent doors, make sure your vacuum lines are connected. also check to make sure your vent hoses are tight. I hope this helps

Jan 11, 2011 | 2007 Dodge Grand Caravan SXT Minivan

1 Answer

Need to replace a front heat blower resistor on 2002 mdx, where is located???


moz-screenshot.pngHere's an excerpt from the 2002 Acura MDX 4WD 6cyl Repair guide for replacing what the reference manual calls the "control assembly" - its located under the console rear trim and may (or may not)
contain the blower resistor - my manual doesn't say - but this is the closest thing I could find for you. Every other blower resistor I've had to find was located close to the heater controls - and this
car seems to be no exception -- its heater controls are located in the console between the seats, rather than in the dash (as in Acura 2003-06 MDX models).

You may want to call your friendly Acura dealership ad speak to the parts department, to make sure where the blower resistor is located - or a visit to a dealership parts counter often (or
Advance Auto Parts is helpful too) ofen clarifies questions I have from Haynes manuals (the cheapest car repair guides).

All this assumes that you've correctly diagnosed your blower control problem -- as in "replace the blower resistor when the blower works only on the MAX/Highest setting."

-- begin excerpt from 2001-2 Acura 4wd 6cyl MDX Repair manual --
Control Assembly Removal & Installation

2001-02 Models
  1. Remove the console rear trim. Refer to the accompanying illustration.

    0996b43f80205cf3.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Exploded view of the console rear trim

  2. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).

To install:
  1. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see whether it works properly.
  2. Run the self-diagnosis function to confirm that there are no problems in the system.

    0996b43f80205cf2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)



  3. --- end excerpt from 2001-2 Acura 4WD MDX 6cyl Repair Manual ---

Jan 02, 2011 | 2002 Acura MDX

1 Answer

My Van has no heat, I have flush the radiator and heater core. It has a rear heater assy is there a ciol in the rear?


The van may have cable or vacuum control for the vent flaps.
Check if the defroster,vent controls are working
If they are,your vacuum lines are good,or your cables are good
Switch from cold to hot.listen for the flap moving(most likely under dash to right of drivers
foot)
Look to see if the heater core had been bypassed(if bought used)
If the flap for cold/hot is not working ,look under dash at center console
try to flip lever manually

Nov 27, 2010 | Mercury Villager Cars & Trucks

3 Answers

I have no heat. We have changed the thermostat


The valve that moves to let the water into the core could be stuck. also check the under dash vac. hoses that control it.

Dec 11, 2009 | 1998 Pontiac Bonneville

1 Answer

2000 gmc sierra 1500 5.3 v8. a/c heater control problem


your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Sep 09, 2009 | 2000 GMC Sierra

1 Answer

Heater only blows hot out of passenger side defrost.


Your Vent Doors Open And Close By Vaucum So Have Your auto Repair man Check Your Vaucum Lines Starting Under Your Glovebox And Then Working His Way Out Under The Hood

Good Luck

Dec 23, 2008 | 1990 Cadillac SeVille

2 Answers

When i drive my vauxhall omega 1999 auto 2.5 cd it reaches 60mph then it starts to shudder as if i am in the wrong gear i have to put my foot down to correct this problem and the engine smells o oi what is...


I'm going to guess and say have the catalytic converter checked.  If that's it...it will also be giving you poor performance and mileage.  
Also replace the exhaust sensors and check the plugs for condition and gap.  Replace the air filter and pcv valve.

Dec 04, 2008 | Volkswagen Scirocco Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Opel Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Brad Brown

Level 3 Expert

15441 Answers

george parkes

Level 3 Expert

975 Answers

Are you an Opel Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...