Question about Cars & Trucks

Open Question

Ihave 2008 detroit 60 series 14l ijust rebuilt engine in frame and have cleaned DLF filter and drve mile check engine and protect engine light came on and then icheck diagnnos it said ecu 128

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Check Engine

The light went out the second day, I’m taking it into the dealer for service mon dec 8, 2008, I did see the brake and radiator fluid to be low, (must remember to buy some at the dealer to keep in my garage) also I have seen small spots on the garage floor on the passenger side forward, I will also have it checked out at the same time. (Who knows! to be continued)

Jack Stravage
Bay Terrace Queens NY
"Those who don’t hear the music think the dancers mad"

Posted on Dec 08, 2008

  • 449 Answers

SOURCE: 2006 Audi A4 - I have an ECU code P0299 -002 lower limit exceeded

You have to pull the code to know what's wrong, do you have any drive ability problems?how different is the car driving after the light come on?

Posted on Dec 22, 2008

  • 41 Answers

SOURCE: i have a 1999 honda odyssey.

Take it to Autozone and get them to read the code. If it is a minor problem (i.e., needs new gas cap) fix it and I would disconnect the battery for about 10 minutes and reset the check engine light. It should go off. If it is a serious problem it will come back on. If not it will stay off.

Before you do this get the radio code as disconnecting the battery will disable your radio and you will have to enter a code. It should have come with the car, If not call the dealer and he should be able to give it to you.

Good luck.

Posted on Aug 07, 2009

  • 401 Answers

SOURCE: where is the oil pressure sensor located on a 60

60 series detroit has oil sender on driver side near rear of engine just above the starter. It usually has 3 wires, and sometimes can be buried in the harness, so you may have to look under wiring harnesses in that area to find.

Posted on May 29, 2010

c1apton15
  • 3400 Answers

SOURCE: check engine light went on today in my 2008 tacoma

Stop by a local Autozone or any good auto parts store and have them do an OBII scan for you. Most will do it for free. They read the fault codes and let you know what triggered light. Have them reset the light for you also.

Posted on Feb 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wht cuases 14l detroit to loose power & blo under load w black smoke in higher gears


It could be a number of things start by checking air cleaner,turbo and charge air cooler pipping and hoses.

Jan 10, 2016 | Cars & Trucks

2 Answers

Fault code 128s254-07 what does it mean


If you are referring to a check engine code for a Detroit Diesel 60 series engine, there are several forum links that troubleshoot the bad code. 1 resolved code involved replacing wires to the ECM and replacing some bad batteries.

2000 Century DT 60 series Engine controller no response page 1
2000 Century DT 60 series Engine controller no response Page 2


Here is image of the wiring diagram the forum mentioned.
c0687617-5874-4473-98cd-a56ced317940.png

Apr 13, 2014 | Cars & Trucks

3 Answers

Check engine light is on. Engine sounds like it's knocking. And oil light is coming on. This 2008 Dodge Dakota has only 63,000 miles.


Sometimes that light means overfill oil
Sometimes after changing oil if they put too much that happens
Check the oil level on cold in level place (give it like an hour or so) for the light to reset
If after that the light still on take it to a tech.

Good luck

Dec 20, 2013 | 2008 Dodge Dakota

1 Answer

Operating oil pressure for 14.0l detroit dieselseries 60


If the engine is at normal operating temperature 25 pounds is fine at idle. Also have you tested the oil pressure with a mechanical gauge, if not you should do so.

Jun 10, 2012 | Cars & Trucks

1 Answer

Where is the oil pressure sensor located on a 60 series detroit


60 series detroit has oil sender on driver side near rear of engine just above the starter. It usually has 3 wires, and sometimes can be buried in the harness, so you may have to look under wiring harnesses in that area to find.

Dec 28, 2009 | 2008 Jaguar Xk Series

4 Answers

Detroit engine series 60


need to look on the ecm make sure all wires are tight and check you cannon plug going in the firewall and check for corrostion unhook and hook back up,I hope this helps you and thank you

May 25, 2008 | 2008 Jaguar Xk Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...