Question about Geo Cars & Trucks

Open Question

Where is the fill plug on a 1997 Geo Tracker 2 wheel drive four door hard top.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
losflip
  • 94 Answers

SOURCE: 1995 geo tracker

If plug wires are arcing at any point, replace plug wires and recheck.

Posted on Nov 30, 2008

Ad

SOURCE: four wheel drive will not work on 1995 geo tracker

You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.

Posted on Mar 09, 2009

  • 583 Answers

SOURCE: need torque setting for 1993 geo tracker front

i1m sorry to say that wheel bearings are not set to a torque specification, when you have repacked the bearings [ inner and outer ] ,reassembled it ,take the nut up until thewheel starts to drag and not turn very far when you try to spin it spin it backward and forward several times,grab the top of the wheel and try to push it in and out,if you getany movement at all tighten the nut a couple of castilations. do it all over again, spinthe wheel a few times and then try for the crossways movement again, if there is no movement ,you are very close to being right....................now comes the experience bit , iwould take it one more castilation of the nut because i know the feel that is need ed,,without that i suggest you put the pin in where you ereput the cap on and go for a 5 minute drive . whenyou get back ,jack it up and thespinning of the wheel again and try for the top crossways movement ,if there is any tighten thenut 2 castilations, and provided that when you try to spin the wheel by hand with a reasonably strong push the wheel should trael about 6 inches at least after your hand leaves it ,it is now a close as you are going to get itput it all to gether and for the next day or so put yor hand on the grease cap after you have driven anydistance, and you will feel it is warm but you should be able tohold your hand on the grease cap. there you have it ,any questions come back."youdoit"

Posted on Nov 06, 2009

  • 1757 Answers

SOURCE: looking for timing belt diagram on 97 Geo Tracker

Click on the following free, direct Link. It has the Timing Belt Diagrams, including Marks and Instructional Diagrams.

Let me know if this helped...

http://www.2carpros.com/car_repair_information/year/1997/make/geo/model/tracker/1997_geo_tracker_timing_belt_diagram_marks.htm

Posted on Apr 08, 2010

  • 72 Answers

SOURCE: 1995 4x4 geo tracker front wheel bearings

first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 97 geo tracker 4 door auto matic in 2 wheel drive it works great but when I put it into 4 wheel drive it acts like it is lunging like something may be bent


if it is in 4 low it will lug also in 4 high if excessive u-joints could be dry and binding or just needs to be ran in 4 wheel for a few miles to lube everything up bearings gears front axle etc... be sure transfer case is full and differentials are full also you need to have same size tires all the way around.

Jan 02, 2014 | 1997 Geo Tracker 2 Door

1 Answer

93 geo tracker wont go into 2 wheel drive stays in 4x4 how to fix it?


after taking it out of four wheel drive try backing up this usually works

Mar 16, 2013 | 1994 Geo Tracker

1 Answer

1997 geo tracker no drive but have reverse ,3 speed automatic


You may try putting the trans in 2 or 1, if this doesn't give you any movement check trans fluid levels hot on a level surface. If levels are correct your trans is probably bad.

Apr 30, 2010 | 1997 Geo Tracker 2 Door

2 Answers

Looking for timing belt diagram on 97 Geo Tracker


Click on the following free, direct Link. It has the Timing Belt Diagrams, including Marks and Instructional Diagrams.

Let me know if this helped...

http://www.2carpros.com/car_repair_information/year/1997/make/geo/model/tracker/1997_geo_tracker_timing_belt_diagram_marks.htm

Apr 08, 2010 | 1997 Geo Tracker 2 Door

1 Answer

How do you remove the drive shaft from a 1992 Geo Tracker?


for 4X4 there are two drive shafts one to the front axel and one to the rear they are bolted to the axels with four bolts and four nuts undo those and gently wiggle the driveshaft from the transfer case. make sure it is in park it makes it easier...

for 2 wheel drive same thing for the rear just wiggle it from the transmission there is no transfer case. just as a warning some gear oil or tranny fluid might leak if the car isnt level

Dec 27, 2009 | 1992 Geo Tracker

1 Answer

How to Replace the crankshaft seal on a 1997 geo tracker


remove belts, pull out crankshaft pilley and then pull put seal

Sep 21, 2009 | 1997 Geo Tracker 2 Door

1 Answer

Need to know how to replace front struts on a 97 geo tracker


three or four nuts on the strut tower to come off, then where it ties into the steering knuckle a spring compressor will be needed to take the mount/bearing off

Jul 07, 2009 | 1997 Geo Tracker 2 Door

1 Answer

Taking down convertible top 1997 geo tracker - nightmare!


both ways huh?
go to best top dot com.
and they have the pdf , right there.

suz uses them.
and tracker is same.

Feb 11, 2009 | 1996 Geo Tracker 2 Door

1 Answer

Four wheel drive will not work on 1995 geo tracker


You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.

Jan 22, 2009 | 1995 Geo Tracker

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...