Question about Cars & Trucks

Open Question

Table doesnt turn on and it is cras. I went to the store and they told us to call tge manufacture

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No break lights are trun lights on the back of my 2009 chevy cobolt all tge lights are good what sould i do i was told the break light switch has went bad but would that stop tge trun lights


The stop lamps on your vehicle are controlled (turned on by the BCM ) - body control module ,turn signal lamps as well . Your vehicle doesn't have a normal brake light switch ,has a low voltage sensor , not to say they can't go bad .
Turn Signal Lamps
The body control module (BCM) is responsible for controlling the turn signals and hazard lamps. When the turn signal switch is placed in either the left turn or right turn position, the BCM receives a signal from the turn signal switch. The BCM then sends an on-off voltage signal to either the left or right turn signals and their instrument panel cluster (IPC) indicator. When the hazard switch is pressed, the BCM receives a signal from the hazard switch. The BCM then will send an on-off voltage signal to all the turn signal lamps. All the turn signal lamps will flash including both IPC turn signal indicators.
Stop Lamps
The body control module (BCM) is responsible for controlling the stop lamps. When the driver presses the brake pedal, the BCM will receive a signal from the brake pedal position sensor. The BCM then supplies battery positive voltage to both left and right stop lamp assemblies and to the center high mounted stop lamp (CHMSL). The stop lamps are grounded at G401 and G403. The CHMSL is grounded at G302.

The first step in the diagnostic process should always be to check for DTC'S - diagnostic trouble code's ,an follow a service diagnostic trouble chart ,testing electrical circuit's .Not listen to someone say it's the brake switch , because in most case's he has no ideal what he's talking about . I have 30 year's GM experience , the level of electronic's on your vehicle , most people just don't have a clue . Your best bet ,take it to a qualified repair shop . That doesn't mean the dealer either . A lot of good independent repair shop's out there .

Dec 10, 2017 | Cars & Trucks

1 Answer

I have a 2012 1500 dodge ram we have tried everything is there any fuel repair kit that will work on a plastic tank


When I was faced with this problem, I went to the store and looked at the "glues & cements" and called the manufacturing companies that were listed on the back of the tubes, and they told me what to buy. Sometimes an "epoxy for plastics" can work.

Nov 25, 2015 | Dodge Cars & Trucks

1 Answer

2006 passat check engine light is on but the car is running good and I keep getting turn engine off warning due to oil pressure but I just changed oil few days ago. the car is running fine so far Also abs...


reset the codes some cras just remove the positive cable . other wise you need a code reader to reset .parts store can usely help you . if the lights come back on the abs is always a connection either the plug in or some cars have a bolt through the wire connection and it needs cleaned to make contact. obviousely the car has oil preasure or it would be clunking and not sounding very good by now check the plug to the oil sender clean and reconnect . if not the oil sending unit is probably B O . and you will need to purchace one from a parts store very easy to change.

May 27, 2014 | Cars & Trucks

1 Answer

Peugeot 407


First thing you beed to do is to check tge fuild level while the car is running cold engine if you see bubbles then its to low check dip stick

Jan 06, 2018 | Cars & Trucks

1 Answer

Knocking noise no heat


try taking out the air con and heater fuse, if the knocking stops than you know that thats your problem.

Oct 09, 2012 | Chevrolet Cars & Trucks

1 Answer

I need to know which o2 sensor is to the code u0D00.


It most likely is the one that controls the vacuum to the transmission. Ask anyone at Autozone where it is located and replace it.

Sep 25, 2012 | 2000 Hyundai Sonata

1 Answer

Hey I have a 2002 2500HD DURAMAX 6.6. THIS MORNING I WENT TO THE STORE AND CAME BACK STOPPED BY THE MAILBOX GOT OUT AND LEFT THE TRUCK RUNNING. AS I MADE IT TO TGE MAILBOX THE TRUCK STOPPED RUNNING! I...


Hi,
9 Volts is not enough voltage for this vehicle. It needs a jump start. Then have the charging checked. It sounds like your alternator hasn't been charging correctly or the battery has finally given up.
Battery can do these sorts of things so have these 2 areas checked.
Let me know how you get on.
Thanks
Jason

Jul 25, 2011 | 2000 Chevrolet 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...