Question about Cars & Trucks
I need to change my fuel sensor and i dont know where its located
You talking about a fuel tank pressure sensor?
It has three wire connector, wire colors, gray--dark green---black.
There are safety issues working under a vehicle, safety is your responsibility.
Posted on Aug 09, 2017
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If The engine in your van is a 3.5L, the knock sensor is under the upper intake manifold. This has to be removed in order to access the sensor on top of the engine block. The job requires an upper intake gasket set and about 1.5 hours to do; if you are handy with tools. For those who aren't; better off leaving this one to the professionals.
Posted on Dec 09, 2008
The electric pump is attached to the fuel sending unit, located in the fuel tank.
Using the GM fuel gauge sending unit retaining cam tool No. J-24187, J-36608 (or equivalent) or a brass drift and a hammer, remove the cam locking ring (fuel sending unit) by twisting counterclockwise. With the locking ring released, carefully lift the sending unit from the fuel tank.
Remove the fuel pump from the fuel sending unit, by performing the following procedures:
When removing the fuel pump from the sending unit, be careful not to damage the rubber insulator and the strainer.
When installing the sending unit, be careful not to fold or twist the fuel strainer or it may restrict the fuel flow.
A brass drift and a hammer can be used to loosen the fuel pump locking cam
Once the locking cam is released it can be removed to free the fuel pump
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.
Posted on Mar 26, 2009
Ther are at leat 3 and maybe 4 o-2 sensors in that particular truck...one on each exaust pipe coming down from manifold...and one after convertor on each bank....Pass.side before convertor is bank one,sensor one ..behind convertor is bank one sensor two..drivers side before convertor is bank two,sensor one...behind convertor is bank two sensor two(If equipped with four....scan will tell you which one is bad....good luck..lee
Posted on Mar 28, 2009
SOURCE: fuel filter location
No, it is in front of the fuel tank right behind the tranny crossmember support somewhat hidden by a metal cover. Easy to see if you just look near the middle of the truck - under the where a back seat would be if you have the 4-door model.
Posted on Apr 13, 2009
Tips for a great answer:
Feb 04, 2013 | 2003 Ford Expedition
May 22, 2012 | 2002 Oldsmobile Bravada
Mar 14, 2010 | 2002 Oldsmobile Bravada
Dec 20, 2009 | 2003 Mitsubishi Diamante
Oct 29, 2009 | 1997 Oldsmobile Bravada
Aug 12, 2009 | 1994 Oldsmobile Bravada
Jun 18, 2009 | 2003 Oldsmobile Bravada
Mar 10, 2009 | 2003 Ford Escape
Jan 20, 2009 | 1992 Oldsmobile Bravada
14 people viewed this question
Usually answered in minutes!