Question about Citroen Cars & Trucks

Open Question

Can someone tell me where the camshaft sensor is located on an 09 citroen dispatch 2.0l version

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

csmock132
  • 4669 Answers

SOURCE: Crank sensor and camshaft sensor

The crank sensor is in the top of bell housing of the transmission towards the back of the engine compartment. The cam sensor is built into the distributor.

Posted on Mar 07, 2009

savdragon
  • 37 Answers

SOURCE: locate camshaft sensor 2002 chevy trailblazer

Assuming you have a 4.2L engine here is the location.
b3031ef.gif

Hope this helps out,
if so please rate my answers.
Brett

Posted on Mar 19, 2009

  • 114 Answers

SOURCE: Camshaft sensor location

The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.

Posted on Mar 22, 2009

emissionwiz
  • 75807 Answers

SOURCE: camshaft position sensor location

At the right rear of the engine under the intake manifold and to the left of the oil filter. You will probably need to go under the car to spot it, it's the sensor with a three-wire connector arranged vertically. But you can take it out from above. It's held in with a single bolt with an eight MM head located just above the sensor. Un-clip and remove the electrical connector. Unscrew the bolt with a socket wrench & extension bar. Wiggle and pull the sensor out.
here is a picture.
255f615.jpg

Posted on Apr 10, 2009

  • 144 Answers

SOURCE: Where is the camshaft position sensor located in a 2001 VW Passat

when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy

Posted on Sep 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Citroen c5 1.6 thp engine, combustion misfiring on cylinder 4 fault, (code P1340), what are the possibilities, and fixes?


Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted -
Camshaft Position Sensor circuit poor electrical connection -
Faulty starter motor -
Starting system circuit -
Dead (Weak) battery

Read more: http://www.engine-codes.com/p1340.html

Nov 05, 2016 | Citroen Cars & Trucks

1 Answer

How do u find camshaft sensor on 09 Chevy HHR and replace ?


this, camshaft,, position sensor,, most of the time is located ,
behind the water pump,, and the timing belt.. but to make sure I recommend to buy the manual, repair book from your local auto parts for your vehicle when calling for the part sometimes the
auto parts store will tell you the location of the part you are
fixing to buy.
second step will be call the chevy dealer service dept.
and they can tell you, where this part goes..
I hope this help.... good luck...

Mar 12, 2015 | 2009 Chevrolet HHR

1 Answer

Where is relay located on citroen dispatch van?


too vague a question without a model, generally 3 locations are possible. Behind cover under steering wheel, behind cover under glove box or in engine compartment under a black rectangular cover.

Mar 10, 2015 | Citroen Cars & Trucks

1 Answer

Fuse box layout citroen dispatch


I have a dispatch 52 plate with no working reverse lights, I THINK I need a new reverse light switch which is ment to be with the bulk of the engine but I cant for the life of me find it, any help would be great

Mar 20, 2012 | Citroen Berlingo Cars & Trucks

2 Answers

I have a citroen dispatch and a warning light on the dash keeps coming on, it looks like a shower head, what is this?


Hi, i'm pretty sure that it's the warning light to tell you to drain the water trap on the bottom of the diesel filter.
Hope that helps Matt...

Nov 22, 2009 | 2001 Volkswagen Jetta TDI

3 Answers

Citroen 2.0 Hdi surging and black smoke


which is standard or the best motor oil for HDI?

Mar 08, 2009 | 2006 Peugeot 604

1 Answer

Crank sensor and camshaft sensor


The crank sensor is in the top of bell housing of the transmission towards the back of the engine compartment. The cam sensor is built into the distributor.

Mar 07, 2009 | 1998 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14333 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...