Question about Cars & Trucks

Open Question

Motor exchange commodore 2000 mod now have no power battery is fine fuses seem to be fine changed computer still no power any where

Posted by on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 369 Answers

SOURCE: 2004 dodge heater blower motor dead. Motor,fuse. relay ck good

most likely that is the problem

Posted on Jan 26, 2010

  • 1024 Answers

SOURCE: have no power to my injectors on a 2000 olds alero

you should have power to the injectors when you turn on the key!


Posted on Mar 29, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Can't find the window fuse for 2003 caddy cts

Check inside trunk under carpet on rear seat back support.

Nov 12, 2016 | Cars & Trucks

3 Answers

2000 holden vt commodore 3.8 What is the firing order please

Since this is just a Buick 3.8 V6 the firing order is

Apr 26, 2016 | Holden Cars & Trucks

1 Answer

How can I be sure if my PCM is bad???

I would try disconnecting battery again. Disconnect both cables and touch them together for a few seconds. This will reset all modules. Wierd that you had so many codes after just disconnecting battery. Sometimes very hard to tell if ecm is bad.

Dec 01, 2014 | 2006 Pontiac Torrent

1 Answer

Battery goes dead intermittently

You have a parasitic drain problem.

Have any aftermarket components been installed?

D/C the negative battery cable and hook an ammeter between the battery terminal and the cable. Anything over 50 milliamps is too high. If it is over 50 milliamps:

Go to each fuse box and pull 1 fuse at a time, check the change in the amperage reading, then plug it back in. If the reading drops to normal levels (below 50 milliamps) when a certain fuse is pulled, the problem is in the circuit powered by that fuse. Find the different components powered by that fuse and check them.

May 17, 2009 | 2000 Subaru Outback

1 Answer


replace the control unit this should solve your problem

Mar 08, 2009 | 2000 Chevrolet Blazer

1 Answer

No power after 2000 rpm

changed fuel filter and disconnected batteries for 30 min. to reset computer. Truck is fine now

Dec 17, 2008 | 2003 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14403 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides