Question about Dodge Cars & Trucks

1 Answer

2005 Dodge diesel fan will not engage. what can I do to check? new fan clutch installed. Did not correct the problem

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 170 Answers

Usually there is a sensor that starts the fan according to the temperature
or blown out fuse

Posted on Apr 29, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Thunder55
  • 318 Answers

SOURCE: 4x4 engagement front axle dodge 2500 2001 5.9 diesel

Sounds like front universal joints have worn out,,without more info,,i cannot help further

Posted on Jan 16, 2009

foskorider
  • 79 Answers

SOURCE: a/c does not blow cold air

ac needs recharged possible leak

Posted on May 21, 2009

roniecon
  • 6927 Answers

SOURCE: 2006 dodge ram diesel a/c clutch makes loud grinding niose

replace the compressor

Posted on Jun 29, 2009

rfoulds85
  • 128 Answers

SOURCE: how do I bypass clutch

To by pass the switch just disconnect the switch and connect the 2 wires from the switch wiring harness together. If it is only one wire then you connect it to a ground source.

This bypass solution is not recommended in any case. The switch should be replaced for safety measures. It is very inexspensive to buy this switch and is well worth the $30.00. My opinion

Posted on May 04, 2011

  • 1 Answer

SOURCE: 2004 Dodge Durango Clutch fan issue

I just replaced my 2004 durango fan clutch and the new fan clutch will not disengage. The fan keeps runnning very loud i have replaced the new one already still doing the samething. Do i have a bad clutch or do i need to have the vehicle idle looked at

Posted on Aug 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Why cant my 2005 dodge stratuss pick up speed when i press on gas pedal


Sounds like a transmission problem, specifically that perhaps the transmission fluid is low if your truck has an automatic transmission, or the clutch is slipping terribly if it has a manual transmission.
- You need to include this information on such questions.

Aug 10, 2014 | 2005 Dodge Stratus

1 Answer

2005 dodge ram cummins diesel only getting 15 mpg


check that the rebuilt box is actually engaging OD. Run fault codes and check it electronically. Have the bands and clutch packs re adjusted as the run in may have put the adjustment out a bit..

Mar 17, 2014 | Dodge Ram 2500 Cars & Trucks

1 Answer

Fan clutch relay


should be a relay , left side fuse panel under hood

Feb 28, 2014 | 1994 Dodge Ram

1 Answer

2005 Dodge Durango A/C Fan will not turn on


The compressor clutch relay is controlled by the pcm. I assume the fan is as well. Is the clutch working?

0996b43f80826278-1bshvg1kqryddsj0au3ml4lo-4-0.gif



0996b43f80826278-1bshvg1kqryddsj0au3ml4lo-4-0.gif

0996b43f80826277-1bshvg1kqryddsj0au3ml4lo-4-5.gif

Jan 23, 2018 | 2005 Dodge Durango Limited

1 Answer

2007 Dodge 2500 5.9 diesel. When you turn on AC you can see clutch try and engauge and after 3-4 tries it stops. No AC. If drive around for a while AC starts to work after engine heats up?


Working same problem today on my 2006 Mega Cab Diesel. 2 possibilities. Either the compressor clutch coil is going bad ( totally integrated power module tries to engage it a couple of times, senses the coil resistance is wrong and shuts down) or the TIPM (Total Integrated Power Module) is bad. I'm leaning toward clutch on compressor but still have testing to do to isolate. Could be both, but I doubt it. New TIPM is about $900 it appears from what I read. New compressor is cheaper. May be able to replace just the clutch coil for even less but reading mixed results. Good luck.

Aug 05, 2011 | 2006 Dodge Ram 2500

1 Answer

2005 dodge ram 3500 overheating when A/C on


Check the fan on the radiator and the fan clutch and relay. It is probably ok when you are driving on the highway but over heating in stop and go traffic which is an indication that the fan is not engaging like it should when the AC is engaged.

Jun 14, 2011 | Dodge Ram 3500 Cars & Trucks

1 Answer

My 2005 dodge caravan is over heating


Check the following:

Coolant level (when cool)
Does fan engage when a/c is put on?
Has the engine been backflushed and new coolant installed lately?
Is the thermostat sticking shut?

Aug 04, 2010 | 2005 Dodge Caravan

2 Answers

2004 Dodge Durango Clutch fan issue, clutch fan disengages after 1-2 minutes after cold startup then engages everytime you come to a stop and start again, temp is just below halfway, I have already...


I just replaced my 2004 durango fan clutch and the new fan clutch will not disengage. The fan keeps runnning very loud i have replaced the new one already still doing the samething. Do i have a bad clutch or do i need to have the vehicle idle looked at

Jul 12, 2010 | 2004 Dodge Durango

1 Answer

Clutch will not engage or disengage. Clutch is new, new flywheel, new bearings.


Look close while someone steps on the clutch. If the fork doesn't move - check to see the cable isn't broken and is in place. If the fork does move - then you put the clutch in backwards. Common one time mistake.

Mar 30, 2010 | 2005 Dodge Ram 2500 Truck

1 Answer

How to remove the fan clutch on a 6.0 diesel


  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove the air cleaner assembly.
  4. Disconnect the radiator upper hose from the radiator. Position the radiator hose aside.
  5. Disconnect the overflow hose from the radiator.
  6. Disconnect the coolant degas bottle hose from the shroud.
  7. WARNING The clutch assembly nut has a right-hand thread and must be rotated counterclockwise to remove it.31a3ca2.gif
  8. 95f52a2.gifUsing the special tools, loosen the fan clutch.
  9. Carefully rotate the fan and fan clutch assembly counterclockwise until the assembly is free from the water pump. Place the fan and fan clutch into the shroud opening.
  10. If equipped, disconnect the retaining clips from the fan shroud.
  11. Raise and support the vehicle.
  12. Disconnect the lower radiator hose retaining clamp from the shroud.
  13. If equipped, disconnect the underbody splash shield from the shroud.
  14. Lower the vehicle.
  15. WARNING Use extreme care when removing or installing the fan, fan clutch and shroud. Failure to do so will cause damage to the radiator.
  16. Remove the mounting bolts, and the fan, fan clutch and shroud.
  17. To install, reverse the removal procedure. Install an appropriately sized worm drive-type clamp in place of the constant tension clamp. Observe the tightening torques shown in the accompanying illustrations.

Jun 20, 2009 | 2005 Ford E-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...