How can I rest a SRS light on my dashboard. have a error code B102D

check for code in the SRS module, then check it out and repair. then clear code. if the light is on then there is a code indicating a problem within the system.

The SRS light is for the "Safety Restraint System" (Airbags). If the SRS light stays lit then there is a problem with the system and it may not function in the event of a crash. Have the SRS system services by a qualified technician. It is not something for the average DIYer.

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

If the srs light is on than there is a problem with the srs system. If the system completed its self check upon startup the light would go out. You can spend a couple grand for a scan tool capable of reading and clearing the codes or spend a hunderd bucks or so to have it checked out. The hundred dollars doesn't seem so bad once it's in perspective.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

There are a number of reasons the SRS light will come on for. Most commonly they are Impact Sensors, Clockspring, and Airbag Module. I don't know what sensors you replaced or what code is showing up, but you may have another bad sensor. This does happen. More likely than that is a bad connection at these sensors. Take them apart and clean all terminals. Make sure they are making good clean contact. Also check for a broken or nicked wire in the area.

Hi.

If the SRS light is on it means that a problem with the SRS has been detected and an error code has been stored in the relevant computer modules. If there is no fault the SRS light will go off after disconnecting battery terminals for five minutes (make sure you have stereo code if needed). Most of the times the light cannot be reset unless the fault causing the problem is fied (e.g. defective SRS sensor). The best thing to do is a code scanning that will also reset the light, followed with troubleshooting and repair of the problem that is triggering the SRS warning.

Regards.


Ginko

Here's a quick check list for most common cost of SRS / Air bag problem.


Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat

(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT disconnecting the negative battery connector to clean the code(s)

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate me answer if it is useful to you.


Cheers,

Mustgo

The Supplemental Restraint System (SRS) is definitely something you want working. Those airbags can be a lifesaver in an accident. Take it back to the Dealer and tell them it wasn't broke before they worked on you car, it's broke now after they worked on it, and stress how much of a Liability this might be. Okay, okay... just ask them to fix it because you would like to have it in case you are involved in an accident. My Civic's Service Repair Manual (from Honda), says Take it To Your Dealer (see below)
===========================================
All SRS electrical wiring harnesses are covered with yellow insulation. Related components are located in the steering column, front console, dashboard, dashboard lower panel, and in the dashboard above the glove box.
Do not use electrical equipment on these circuits.

-WARNING
To avoid rendering the SRS inoperative, which could lead to personal iniury or death in the event ol severe frontal collision, all SRS service work must be pertormed by an authorized Honda dealer

hello, p0170 and p0173 is describe as self adaptation of mixture formation to limit ,possible cause are air leak,fuel injector,our engine is too sensitive in fuel octane,,, in your srs/esp problem, sometimes only ,battery voltage drop,srs/esp appear in cluster,only dealer have the star diagnose to erased the fault code,