I have fitted a towbar on a toyota runx rsi. If not how and where to connect wiring. Should i bridge wiring from existing connectors at tail lights to tow bar lug.Thanks.Vinod

SOURCE: wiring a tow bar

you will need proper adapter then it will need coding to the unit if it is on canbus system

SOURCE: tow bar wiring

Go to U-haul, and they have a kit to make it easy to fix your problem.

SOURCE: I have a 1998 audi A6, the rear fog light is not

could be a relay or maybe even a cable break, hope it is the former, sound like a job for auto electrician.

SOURCE: Tow bar trailer socket wiring connection point to car wiring?

The connectors for towing wire harnesses on foresters are generally on the passenger side, below the rear taillight inside the cargo space. some require pulling up the foam block that is between the spare tire compartment and the taillight. Check where you replace the tailights from inside the car, if there isn't a matching connector hanging out there, check around the spare tire compartment, see if you can remove the carpeted foam block next to the compartment and find the plug under there.

SOURCE: i have all relevant diagrams

Hi There it may be easier to trace the required wire from each light cluster and splice in the towbar electrics rather than follow a hand book wiring diagram ie; pin 1 Yellow L/H direction indicator. go to left hand cluster and locate left hand indicator wire, stip back the tape binding enough so that you have enough to play with and then splice in the Yellow towbar wire and continue onto the next wire on the list. Good luck

Testimonial: "cheers pal, very helpful"