A warning light hhas come on. Its a white car indicating something at the front of the car. I have a new micra

Have you had a battery disconnect recently? Did you try resetting the the security system and engine immobilizer?

K12 SE AUTO,Removed Battery Terminal Now Car wont start

Micra Sports Club https://micra.org.uk > K12 General Discussion
Jan 4, 2023 - 1. Leave the ignition key in "ON" position for approximately 5 seconds. 2. Turn ignition key to "OFF" or "LOCK" position and wait approximately 5 seconds. 3.

K12 security indicator warning light on red - Micra Sports Club
Jan 6, 2023
K12 nats problems ' Micra Sports Club
May 8, 2020
K12 1.2 Non starter immobiliser ' Micra Sports Club
Mar 4, 2021
K12 (2004) Power Steering Fix - Micra Sports Club
Jan 9, 2023
More results from micra.org.uk

HOW TO: Reset ECU (Clear DTC codes) - Nissan Forum

NICOclub Forums https://forums.nicoclub.com > how-to-reset-ecu-clear-...
Aug 24, 2009 - 1. Turn ignition "ON" (without starting vehicle), count to 3 seconds. 2. Depress/Release accelerator pedal 5 times...hard and fast. 3. Count to ...

Security system reset - Nissan Forum
Oct 17, 2018
Immobilizer tripped? How to reset or figure out how to start car
Feb 22, 2020
More results from forums.nicoclub.com

The spanner symbol indicates a service is due!

as for the car not starting......get the codes read from the OBD connection and check the fault codes, this will indicate where the issue is.

that is telling you there is a problem with the speed sensor. is there any other warning lights

Try the following:

"KEY FOB PROGRAMMING
NISSAN
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and hazard reminder. When the doors are locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key?s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key?s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds."

2005 Instrument cluster layout

1. Speedometer
2. Brake warning light
3. Turn signal indicator light
4. High beam indicator light
5. Malfunction Indicator Light (MIL)
6. Airbag warning light
7. Anti-Lock brake warning light
8. Tachometer
9. Security alarm indicator light
10. Oil pressure warning light
11. Electronic Stability Program (ESP)/
Traction Control System (TCS) indicator light
12. Tire Pressure Monitor warning light (base)

13. Temperature gauge
14. Electronic Vehicle Information Display
15. Tow/Haul indicator light
16. 4WD Low mode indicator light
17. Seat belt reminder light
18. Cruise control indicator light
19. Odometer/Trip Odometer
20. Transmission gear indicator
21. Fuel gauge
22. Electronic Throttle warning light (5.7 Hemi)
23. Front fog light indicator light
24. Voltage warning light

I have not used my nissan micra 2003 for 7 months it has been stored in the garage but the engine has been started on a weekly basis but today the warning engine light has come on, the car has only done 2300 miles, SHOULD I BE WORRIED or is it because the battery has been disconnected in between starting the engine so it didnt drain the battery while it was standing in the garage unused, this has happened the day before i take it for a mot.....

get a new battery for key then put key in ignition and turn on and off 3x times and that should reset alarm

OH YES !!!! u have to get ur car computer scanned right away. Theres surely a problem on the way, and before it gets worse, get it scanned and u will easily get to know what needs to be changed. So instead of changing 3-4 things when its gets worse, its better to change only the thing which is required right now.

DO IT RIGHT AWAY !!!

Your best bet is to go HERE and signup for a free account then Downloading your Manual - service sheets, diagrams, parts lists etc.
Hyundai is one of the best with providing their customers with free information about the vehicles!!

I have D/L the manual, and the warning lamps on the instrument cluster are...
Left to right...(starting under temp. Gauge)

WITHOUT TRIP COMPUTER
11. Traction Control Indicator Light (If installed)

12. ABS Warning Light (If installed)

13. Seat Belt Warning Light

14. Oil Pressure Warning Light

15. Charging System Warning Light

16. Parking Brake/Brake Fluid Level Warning
Light

17. Malfunction Indicator Light (MIL)

18. SRS (Airbag) Warning Light

19. Trip Odometer/Odometer

20. Trip Odometer Reset Knob

21. Low Fuel Warning Light

WITH TRIP COMPUTER

7. Front Fog Indicator Light (If installed)

8. Door Ajar Warning Light

9. Trunk Lid Open Warning Light

10. Parking Brake/Brake Fluid Level Warning
Light

11. Malfunction Indicator Light (MIL)

12. Charging System Warning Light

13. Oil Pressure Warning Light

14. SRS (Airbag) Warning Light

15. Cruise Indicator Light (If installed)

16. Seat Belt Warning Light

17. ABS Warning Light (If installed)

18. Traction Control Indicator Light (If installed)

19. Automatic Transaxle Position Indicator Light
(Auto T/A only)

22. Low Fuel Warning Light


Thanks for using FixYa - a FixYa rating is appreciated!!

Hi fisics,
I believe that corroded terminals in the light cluster can cause the warning light to come on.

But I once read that there is something else, entirely unrelated to the indicators themselves, that can cause this warning. Possibly another system powered through the same fuse or relay...When I remember what it is I will get back to you. It's pretty late here in Scotland. :-)

Cheers, D.