Question about 1993 BMW 3 Series

1 Answer

Blower for ac

Menchanic installed the new blower on the bmw 325 1 then it blew up why told me to go to the dealer

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 239 Answers

Sounds the Blower resistor is bad.

Posted on Sep 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bmw 325i automatic transmission,how do you replace the blower motor on 1995 BMW 325 i


on older models you have to detach the firewall plate within the engine compartment to reach the blower motor. That's where I would start looking on the '95 model too.

Jan 14, 2014 | Cars & Trucks

2 Answers

My ac blower motor burned up, how do I remvoe the dask to reinstll a new blower motor?


BEST TO LET BMW DEALERSHIP REPLACE HEATER BLOWER IF NOT MISTAKEN YOU HAVE TO DISCHARGE AC SYSTEM TO REMOVE REFRIGERANT LINES TO REMOVE BLOWER MOTOR COVER.THIS IS NOT HOME FIX.BMW CARS NOT EASY TO WORK ON.YOU HAVE TO BE BMW MECHANIC TO WORK ON THEM.

Jul 01, 2011 | BMW 325 Cars & Trucks

2 Answers

Bmw e90 fuel


YOUR BATTERY SAFTEY TERMINAL MOST LIKELY BLEW (ON POSITIVE BATTERY CABLE ON RIGHT SIDE OF TRUNK). NEEDS TO BE REPLACED. SEE A DEALER.

Jan 09, 2010 | 2003 BMW 325

1 Answer

Cant find blower motor resostor on bmw station


you must remove glove box,remove lower cover below glove box, get under dash and use flashlight and you will see the fan resistor in the evap box, it maybe held in with a t 20 torx screw otherwise pull aside tab and pull out

Oct 16, 2009 | 2001 BMW 325

2 Answers

Where is the fuse for the AC on 2003 bmw x5


It should be #28 fuse (Blower, AC)

Jul 26, 2009 | 2001 BMW 325

1 Answer

Sour Vinager odor in vents when using AC in a 2003 325i???


milk may have been split in the vents
it goes very sour & vandals sometimes do it on the street!

Jul 20, 2009 | 2003 BMW 325

1 Answer

My battery died. Got a jump and the fan motor for the AC will not work. I checked all the fuses I could and they seem fine.


Here is a fuse diagram for your car K4 is the blower relay if this is good you need a new blower motor Good Luck To You
d947134.gif

Jul 17, 2009 | 2001 BMW 325

1 Answer

THE A/C BLOWER DOES NOT WORK IN MY 2002 BMW. THE FUSES HAVE BEEN CHECKED AND ARE OK. WE HAVE OREDERED A BLOWER SWITCH. WE NEED A DIAGRAM ON WHERE TO INSTALL THIS IN MY BMW.


On the passenger side footwell. On the left, one philips screw to remove carpet panel. Black plastic piece needs to be removed, some have plastic nut to turn to remove. Some just pull towards the back of the car and down at the same time. Tucked in there is the blower resistor "blower switch" with a 4 or 5 wire connector on it. With right hand push on tabs and remove connector. Then with right thumb and index finger grab the blower resistors connector and with your middle finger push down on the plastic tab and pull out. When installing new one make sure to line up the guide pin.

Jun 19, 2009 | 2001 BMW 325

1 Answer

My ac is blowing at various strengths no matter what setting


the final stage transistor(blower resistor) has failed most likely. It controls blower speed from a signal from the ihka (a/c control panel). the final stage receives the signal from the ihka of drivers preference blower speed. the final stage pwm (pulse width modulates) the blower motor. which means it turns it off and on very quickly to speed up or slow down the blower motor speed. It isn't the easiest part to replace. Usually at a dealership i would expect to pay somewhere around $600 (including diagnosis)but don't hold me to it. bmw dealerships stand behind their repairs and usually include a warranty with the part of 2 years unlimited mileage.

May 03, 2009 | 2003 BMW 325

1 Answer

2001 BMW 330i..Fan for AC/vent not working?


it's either a fuse or it's a bad blower motor, it could be a bad blower motor resistor but usually you'll get either high or low only, so if you have nothing on any speed, high low etc, and all the fuses are ok chances are it's your blower motor.

Jan 16, 2009 | 2003 BMW 325

Not finding what you are looking for?
1993 BMW 3 Series Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...