Question about 1988 Ford Ranger

1 Answer

Loss of fuel pressure on 1988 ford ranger

Truck runs fine until get warm, replaced both fuel filters, new tune up, and distributer cap and coil

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,140 Answers

Some of these trucks had 2 fuel pumps. One in tank other in frame rail. Possible bad/weak pump.

Posted on Jul 27, 2009

  • Paul Ciccarello
    Paul Ciccarello Dec 15, 2014

    1988 was the last year they say



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1988 ford bronco11 have feul,but no fire from distributor to coil

with distributer cap off have someone crank engine and see if your rotor is turning if not repair distributer or replace.

Apr 05, 2014 | 1988 Ford Bronco II

1 Answer

After 60 or higher sounds and runs bad loss of power, lifters r load

dont forget the trans-if auto then the torque converter or other cud b worn--do a pressur test on trans--------also the injector drivers in computer cud hav issues----may want to do a compression test on engine too--the gaskets are aging also as well as the sensors etc--must b a lotta miles on car--amsoil synthetic will rejuvenate any seals in engine--1st time u use it -u see leaks outside while it cleans motor then u drain and nex change its cleared up

Apr 03, 2014 | 1988 Ford Bronco II

1 Answer

1988 Ford Ranger Fuel Injected 2.9L V-6 4x4 Stick shift It turns over but won't start, it has spark and fuel and the exhaust is not plugged, i replaced the O2 sensor and a control module on the back of...

Check the compression? You replaced all the items to make it run. remove the air filter and check? If compression is below 90 then bad rings or valves. Check the fuel pressure. to see if you have bad rings with low compresion spray oil in cylinders, if pressure goes up it's the rings. If nto it's the valves.Try these and let me know.

Nov 10, 2010 | 1988 Ford Ranger

1 Answer

My 1988 Ford ranger runs fine until it gets warm then?

Holding to floor goes really fast or not? If not, check for burnt valve.

Apr 07, 2009 | 1988 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides