Question about 1987 Dodge D150

1 Answer

1987 dodge d 150 not firing

My battery also fell of and unpluged my lead wire and wont fire have tryed everything can someone help me

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Change the battery cables,use a wire brush and clean the battery posts

Posted on Jul 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1990 Dodge Ram 150 with the 318 engine that the coil isnt sending fire to the dist...But the coil is good. Could someone help?


Could be a bad coil, or a bad pickup coil inside the distributor, or worst case a bad pcm.

You said the coil is good, but didn't mention if you had tested the coil's primary and secondary circuits with an ohmmeter to see if they are within specs? And the pickup coil is like a crank position sensor: it tells the pcm crankshaft position and rpm so the computer can determine spark timing.

Dec 19, 2014 | Dodge Cars & Trucks

2 Answers

I need the firing order for the wires to the distributor cap.


there are several engines--please pick yours.

V8-318 and 360 EnginesEngine Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise:
jturcotte_117.gif




V8-400 and 440 EnginesEngine Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Counterclockwise:
jturcotte_118.gif


V8-383 and 44 EnginesEngine Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Counterclockwise:
jturcotte_119.gif

Nov 08, 2010 | 1987 Dodge Ramcharger

2 Answers

My 1987 dodge w 150 wont hold a charge ive changed the alernator battery as well as the voltage regulator. when i charge the battery it holds a charge for about 5 to 6 starts


Could be a short. Have you checked the voltage at the battery with the car running? Is it over 14 volts?

Please see my tip at http://www.fixya.com/cars/r5925550-dead_battery_troubleshooting . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Oct 19, 2010 | 1987 Dodge W150

1 Answer

Where can I find a diagram for the plugs and wires on a 1987 Ford F-150 302 V-8 engine?


the firing order is on the intake manifold. If the wires and plugs are out take the distributor cap off and crank the motor slightly and see if it turns clockwise or counterclockwise. Bring #1 piston up and put the plug wires on according to the firing order.




Sep 03, 2010 | 1987 Ford F 150

1 Answer

1500 Ram wont start, no crank no click nothing. Air cond and dash lights work just fine just wont start. Battery is ok tried to jump, no luck, put in different battery no luck.


First thing is to check is the ignition fuse/relay under the hood for a blown fuse or bad relay. If everything is ok then set parking brake with truck in park/netural and have someone to turn the ignition over to start and at the same time use a test light to check for fire at the starter solenoid. If no fire then the ignition switch or netural switch on transmission is causing the problem. If you do have power to the starter solenoid then the problem would be either the solenoid or the starter drive locked up on the flywheel. Be sure to remove the negative wire from the battery if you need to remove the starter. Hope this will help you.

Jun 02, 2010 | 2008 Dodge Ram 1500 2WD

3 Answers

Im having a problem getting my 87 f150 302 to start. it turns over but just wont fire up. like it started just fine one day then i came out the next and nothing. iv tested the control module and the...


If you are getting fuel and spark at the cylinder then check the timing. It's not uncommon for worn timing chains to jump at shut off or start up. To check turn the engine over until the timingmarks on the crankshaft line up at 0. Trace the wire back from #1 piston, which is the front one on the passenger's side. On the cap it should be just to the right of the tab that locks the cap in the proper position on the distributor. Lift the cap and check the position of the rotor button. It should be directly under the tower for the wire or it should be 180 degrees off. If so turn the engine 1 turn until the timing marks line up at 0 again and look under the cap. If it's not lined up with the #1 wire, turn the distributor until it does. Tighten the distributor down and try the truck. If it fires you are looking at replacing the timing chain. If it jumped once it will jump again. Hope this helps.

May 29, 2010 | 1987 Ford F 150

1 Answer

Help please i have a 1987 dodge ram pick up that died on me on the hyway i find now there is no spark from comming out of the coil i ran a positive wire direct from the battery to the Pos. Side of the coil...


Check the ballast resistor mounted on the fire wall. It's white about 3 inches long with one screw in the middle. Use a test light and check to see if you are getting fire across both terminals. If not replace it. Fire comes from the ignition through the starter relay to the ballast resistor and then the coil. Hope this will help you.

May 20, 2010 | Cars & Trucks

1 Answer

Nofirefromcoil ona87d150


You need to re-set the security system...I don't know if it will work on a dodge but since Jeep and Dodge are both Chrysler products, (it works on Jeep) Try closing the doors and using your key, lock then unlock the drivers door. If it works tell me so I can add it to my list of "tricks" good luck.

Mar 17, 2009 | 1987 Dodge D150

2 Answers

87 dodge ramcharger not firing


Pull the coil wire out of center of distributor cap and lay it close to where you unpluged it from distributor cap, and turn over engine if coil is good you will see the spark jump. If no spark coil bad.

Mar 03, 2009 | 1987 Dodge Ramcharger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...