Question about 1994 Toyota Camry

2 Answers

Ac switch doesn't change air flow positions - 1994 Toyota Camry

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 166 Answers

Hi it probely a vac hose off or cracked or broken

Posted on Jul 27, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

Cable on heater control head may of come off, or it may of come off on blendoor side. You may be able to gain access by removing glove box. Blend door cable is behind glove box.

Posted on Jul 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my pontiac torrent overheat when ac is on


sensors......Water temp sensor, air flow temp sensor, MAP sensor, Idle speed control solenoid, throttle position sensor, O2 sensor.........
Engaging AC draws on power from your motor, resulting in the ECU having to compensate to keep revs stable. Increased revs result in increased air flow, water flow, fuel flow & exhaust emissions.
Check belts for your AC pump first, as the same belt may drive your water pump. If it slips under load when the AC is on, ..................... Say no more. Next replace Water temp sensor. No luck..... ISC solenoid....
.

Mar 22, 2017 | Pontiac Torrent Cars & Trucks

1 Answer

Why center AC vents blocked? all others fine


The flap that directs the airflow between your front defrost and those Center vents sounds like it is become disconnected from your control

Dec 20, 2017 | Mitsubishi Outlander Cars & Trucks

1 Answer

Sentra AC


There's a 10amp fuse that powers the ac clutch relay and compressor. There are 15amp fuses that power the blower motor and the ac control switch. All of those fuses get power from the key switch. The resistor and fan switch provide the ground circuit for the blower motor.
I would want to know if those fuses are getting power, and if the control panel is working. You should be able to ground the blower motor and make it run on high, and that should not have any effect on if the ac compressor is running or not.
It could be a key switch problem in that the circuit is not strong enough to handle the load from the blower and the compressor at the same time.

Jun 21, 2013 | Cars & Trucks

1 Answer

Nissan sentra air conditioning


The flow switch it change's howthe air flows get a motor manual at auto parts stir about 25 bucs it will tell u what up

Apr 29, 2013 | Cars & Trucks

1 Answer

Air regulator valve on dash for heat and AC stuck in on position. Ram 2500, 2004.


The most common problem is a stuck or faulty blend door under the dash.

Feb 22, 2013 | Cars & Trucks

1 Answer

Air conditioning switch on dash doesn't seem to work. How can I test it?


Remove the wire plug to the AC switch and then use DVM (Digital Volt meter) set to resistance at say 200 ohm range and use the meter probes across the two exposed terminals of AC switch (depressed position) to see if you read low resistance. If so it shows switch is working.

Mar 25, 2012 | 1989 Toyota Camry

3 Answers

2003 ford e350 handicapped conversion only blows hot air out the rear ac


you will need to check the rear blend door actuator.

Jun 21, 2010 | 2002 Ford E350

1 Answer

Hi, Expert, My Caravan is 2001, recently the switch of AC air flow just work on the strongest position, if put the switch on other position, then no air come out, and probably the temperature switch has...


Good day
If it's only running on high sounds like is the blower motor resistor. The resistor is located in the AC housing behind the glove box, a very easy to replace. the resistor controls the speed of the motor. after you replace this you should not have a problem

hope this helps

Cheers

Jul 13, 2009 | 2000 Dodge Caravan

2 Answers

Why does the ac on my 2003 ford f150 blow through the defroster


Most likely it is a vacuum problem. That's what controls the air flow flaps.

Jun 21, 2009 | 2003 Ford F150 Regular Cab

1 Answer

Can't change air flow direction on ac/heater control. Only blows up to windshield.


It will be a cable that will be disconnected. or broken. Youll have to take some of the dash apart to see the cable and follow it to the switch. Dont be affraid to take some things apart and when you cant see, use a mirror to help you see behind the dash. work the control and watch the action. You will fix this dont get frustrated. good luck

May 22, 2009 | 1998 Ford Taurus

Not finding what you are looking for?
1994 Toyota Camry Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...