Question about 1991 Oldsmobile Cutlass Ciera

1 Answer

Car wants to stall while driving

While driving the car it runs fine for about 20 min, then it will spit and sputter, and when you slow down it will stall out, when you refire the car, it will run fine until you put it in gear (R or D), it stalls out again.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

Check for trouble codes first thing, It could be a number of things. example, mass air flow sensor, map sensor, crank sensor, ignition module. Check for codes first to see if there are any. That will help you get on the right track

Posted on Jul 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my air conditioner make my car stall?


If your A/C compressor clutch is binding or seized, - the extra load will slow down the engine as everything runs on 1 belt on this car - check your Freon level and refill or replace the clutch/compressor

May 21, 2017 | 2000 Ford Focus

1 Answer

I have a 1996 Honda Accord with 268k miles that sputters at the same timethe speedometer needle fluctuates wildly. But I do have a new Vehicle Speed Sensor. This typically only happens when the engin


I am no Honda expert, but a similar problem happened to my ex sister in-laws Ford Taurus. The speed odometer would jump around and it had trouble shifting (automatic transmission). After driving it I changed out the speed odometer sensor on the transmission and it's been fine ever since. I changed out the sensor because if the cars computer cannot tell how fast the car is traveling then fail safes in place go into effect and the computer will do it's best to keep the cars rpm's down based on the speed indicator and not let it shift or shift properly either. If it's getting false speeds then it will shut down the motor when the speed gets to high and allow it to run as the speeds fall (jumping speed odometer needle). It effects the transmission shift points also. It will either shift erratically or not shift out of say 2nd gear, so that the cars engine can't get damaged based on what signal the speed sensor is sending the computer.

Jan 23, 2014 | 1996 Honda Accord

1 Answer

94 trailblazer runs really rough for awhile after sitting ,after running awhile its starts to run fine (worse on cold days) help please!!!


Have a pressure bleed down test run on the fuel pump, that is the most common problem that causes this condition.

Aug 23, 2012 | Cars & Trucks

1 Answer

Stalls in drive, runs grear in reverse


Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Jul 06, 2012 | Cars & Trucks

1 Answer

My jimmy will start and idle just fine however when I start to drive it,it sputters and spits then stalls out. when I restart it I have to floor it to get it to start again. if I rev it to about 6-8000...


i would suggest changing the fuel filter if this does't work check the fuel pressure. and get a mechanic to check the ecu fault codes. as this could be caused by a electronic fault.

Mar 09, 2011 | 1996 GMC Jimmy

1 Answer

92 max Sputtering and stalling out??


sounds like your crank triger after it cools then does it fire up fine then when it warms up it dies if so it would be your crank triger

Aug 09, 2009 | 1992 Nissan Maxima

1 Answer

1995 Jeep grand cherokee is missing while running. When it is under a heavy load (driving fast) it runs fine. When idleing and slow driving it spits and sputters.


I have the same problem on my 95 grand cherokee laredo. Sometimes it starts out fine and after about 10 miles it starts spitting and sputtering. Then after a while it seems to clean out and run fine again for a little while. Then other times it starts out spitting and sputtering at the begining. I changed the fuel filter and that was not it. It is a 4.0L 6cyc. Any Ideas?

Thanks,
Broken Arrow, OK

Jul 02, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Sputtering


sorry to be the one but its your fuel pump.. good luck keith...p.s. try the filter first...

Mar 20, 2009 | 1997 Chevrolet Blazer

Not finding what you are looking for?
1991 Oldsmobile Cutlass Ciera Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...