Question about 1998 Toyota Camry
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This site will tell you what you need to know. good luck with this.
http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm. In addition to the advice at the above site, I found another trick to removing the trim around the inside door handle. The above article refers to putting a screwdriver UNDER the door handle and pushing down ... to release a "secret latch". That's the first step. The second step (which is not in the article) is to insert the scredriver ABOVE the door handle ... vertically above the spot shown in the article. Then gently press the screwdriver handle down. With the screwdriver acting as a lever, the tip of the screwdriver will push UP on the top part of the trim. That will lift the trim up off a small pin on the handle mechanism. With both the bottom and top of the trim piece now "unlatched", slide the trim toward the back of the car, while you open the inside door handle (as mentioned in the article). The trim will come right off. Be sure to slide the trim toward the back of the car, as you move the trim away from the door panel. (There is a "hooked" piece of plastic on the back of that trim that prevents you from just pulling it out perpendicular to the door panel.) 'Hope these fine points help.
Posted on Feb 13, 2009
Yes, you have to remove the door panel.
Remove the 2 plastic protectors on the front edge, and remove the 2 brass colored screws. Next, remove the push pins from the latch side. Push in, and pull out the whole thing. Next, under the armrest, remove the screw. Lift up the power windoe control, being careful to not break the plastic retainer tab. Remove the screw under the window control. Starting at the bottom, pull out the panel, and, when all of the clips are loose, pull the panel straight up. It is best to do this with the door panel as warm as possible, like in a heated garage. Doing this outside in the cold will break all of the plastic retainer clips; they are quite brittle whn cold.
I hope this helps
Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated.
Posted on Feb 23, 2009
Start with a good thick pair of leather gloves, a putty knife, and a tall trash can. Place the trash can below the mirror, tilt the mirror inward so you get a hold of the outer edge, and carefully pry the remaining pieces of mirror from the backing plate. Do not apply any pressure directly to the backing plate, or you may damage the gears on the electric motor. You should be able to pick up a new mirror and adhesive at your local auto parts store. Use masking tape and a couple of wood blocks to hold the glass in place while the adhesive sets (blocks against the glass, then wrap the whole thing in tape).
Posted on Feb 27, 2009
Heated mirrors usually have a symbol on them -- a small diagram showing squigley heat lines.
If you don't see this, it's probably not heated. But when you take the mirror off, if it's heated it'll have wires connected to the back.
Yes, you can replace a heated mirror with non-heated -- just leave the wires tucked out of the way when you install the new mirror.
Posted on Apr 29, 2009
To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.
Posted on Jan 06, 2010
Tips for a great answer:
May 05, 2015 | Cars & Trucks
Mar 25, 2013 | 2009 Toyota Camry
Oct 17, 2012 | 1998 Toyota Camry
Nov 17, 2011 | 2000 Toyota Camry
May 06, 2010 | 1997 Toyota Camry
Aug 30, 2009 | 1997 Toyota Camry
Jul 19, 2009 | 2002 Toyota Camry
Apr 29, 2009 | 2004 Toyota Camry
Feb 21, 2009 | 2003 Toyota Camry
Dec 05, 2008 | 2002 Toyota Camry
197 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: