Question about 1998 Toyota Camry

1 Answer

Whining sound on acceleration

Whining when the vehicle hits 1800 RPM, levels out and dies above 2000.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 31 Answers

Could be your rear end ... check if the bolt is tightened that connects to the big pipe that goes all the wa across the middle under ur truck ...it might take a few hours to do this .. note:if u dont have experience fixing that certain vehicle then contact a auto shop ... have them fix it for u.

Posted on Jul 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 chevy silverado 1500 with the 305 auto. It will start and idles just fine. But if i turn the AC on, or put it in gear. or put any strain at all on the engine it will start to hesitate and...


if it has a carby ( you didn't bother to mention carby or EFI), have the carby overhauled as from your description, the accelerator and power sections of the carby are not working, Blocked jets or low float levels
if it is EFI have the fault codes read to check for MAF/VAF sensors and/ or heated oxygen sensor problems
your description indicates that the engine is not getting excess fuel to provide engine rpm acceleration be it either carby or electronic system

Mar 22, 2017 | Chevrolet 1500 Cars & Trucks

1 Answer

DEFINITE LURCH IN 1ST AND 2ND GEAR,


This may apply. ...............................

Carry out the adaptation drive cycle road test:

Note: This process must be carried out in normal mode (not sports mode). On a flat road, the transmission fluid temperature must be above 60° C (140° f) and below 100° C (212° f) (vehicle at normal operating temperature will ensure that the transmission fluid temperature is above 60° C (140° f)).
9. Accelerate from rest with light throttle (do not exceed the upper rev limit in appendix 1). 1-2, 2-3, 3-4 shifts must occur with engine speed between the following limits:.
Note: Do not move the accelerator pedal during shifts.

• 3.0L VIN ALL 1800 - 2000 rpm
• 4.2L N/A Prior VIN M96321 1450 - 1600 rpm
• 4.2L N/A From VIN M963221550 - 1700 rpm

10. Continue to accelerate gently to 50 mph (80 km/h) so that transmission shifts into 5th gear.
11. Go into overrun and let the transmission shift down into 4th gear without braking.
12. Brake gently to a standstill and hold footbrake on for at least 15 seconds.
13. This process should be carried out at least five times.

Page 2 of 3 Bulletin Number S307-17
________________________________________________________________________________

Jan 17, 2011 | Jaguar S-Type Cars & Trucks

1 Answer

Whine from 2005 corolla automatic transmission


Have the tranny serviced with fluid change and filter, if noise it still there it is the torque converter . Have the dealer fix it ,and have it on paper with dealer invoice when it is done. Do all this before warranty expires. IT IS NOT USUAL for any car, Toyota included, to have tranny whine!!!!!

Jan 23, 2010 | 2003 Toyota Sienna

1 Answer

Whining from rear of vehicle only when accelerator


Check the rear differential fluid level and or condition of the fluid. if it is low you could have a bad pinion or carrier bearings (common in jeeps) you may need to remove the cover all together and all the fluid will drain out. you should be prepaired to catch the fluid in a pan and also have gasket sealer to reinstall the cover. Usually you can just remove the rubber plug on the cover and the fluid should be just at the edge of the bottom of the hole when the vehicle is on level ground. if there is no rubber plug on the cover then there is a fill plug on the passenger side of the differential just above and a little further back from where the pinion goes into the rear axle housing. if there is any signs of metal or a silverish color then you are getting failure of some sort in the differential (axle)- usually bearings. the pinion bearing is usually the first to fail because of the speed it spins at and the fact that the force used to spin the carrier wich turns the axles is taken off the side of the pinion gear. if the oil is clean and full but smells prety bad.. -this is normal. removing the cover can be a project so if you are intimidated by the sounds of it then take it to a professional and save yourself a towing charge. i would rate the difficulty at about a 3 out of 10. make sure you use the proper fluid to refill it also. good luck. let me know if you want more help from me.

Dec 30, 2009 | 2000 Jeep Grand Cherokee

4 Answers

Loud accelerating whining


It is the bearing in the idler pully. about $35 and 30 minutes of work and its fixed.

May 20, 2009 | 2006 Chevrolet Trailblazer

1 Answer

Engine miss above 2000 rpm


sounds like a valve problem. check compression running and non-running. valve sealing at higher rpm is usually a valve spring problem is if runs ok at idle.

Oct 22, 2008 | 1990 Jeep Wrangler

2 Answers

Air Condition


it sounds like a loose compression compressor.

if the compressor is loose compression, normally it sounds noisy. then suction pressure is above normal and if you accelerate and maintains that high speed, let say 2000 rpm, the suction pressure goes down to the normal level and cools your air conditioning .

tnx 4 using fixya...

drcool

Aug 29, 2008 | 2004 Nissan XTerra

Not finding what you are looking for?
1998 Toyota Camry Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...