97 Lumina security light is on but runs fine today the bright light indicator light on dash came on but bright lights were off. Light stayed on but went back off what's the deal with both lights

The 98 lumina LTZ has No light on dash for low fuel, there is not an indicator for low fuel except for the guage. Don't wait for a light to flash, or you will run out of fuel:)

It is supposed to be that way,to let you know that your lights are on automatically,they go out when you are driving at night. They're a safety feature that was introduced back in 1995.It also can be overridden in the dash lights.

flasher relay under steering column does not work,switched it with hazard and see if it works,then get the new one,make sure the light on turn signal in front or back is not burned out first

there is a regulator for the display brightness, you may have it turn'd down or it has stopped working;. it controls the brightness at which the dash lights are. usually has a speedo sign on it. goes up and down. it works with the main light and is conecter to them on the same lighting board if it has gone then a new light swtch control switch will be needed.

There may be a relay somewhere. Try rotating the bright dim switch for the dash lights.

may need to change ignition cylinder

Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

their is s security code in your owners manual or call dealer ask for your modelsecurity code to reset on radio dial?

For the security light you need to replace the ignition lock cylinder or bypass the security system. For the other two, you need to have the car scanned to see what codes are in the ecm and the abs module.

This is most likely the security system light.