Question about 1999 Dodge Intrepid

2 Answers

My windshield washer fluid light is on

My windshield washer light is on an i put some fluid in but the light don't want to go off

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 115 Answers

The contacts in the sensor could be shorted. Try replacing it.

Posted on Jul 27, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 32 Answers

Try changing the sensor in the resevoir.

Posted on Jul 26, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: Windshield washer fluid will not pump

the windshield washer pump might be bad. It should be located somewhere on the reservoir

Posted on Nov 27, 2008

  • 205 Answers

SOURCE: Rear windshield washer motor works, but no fluid comes out

Rear washer may have it's own reservoir . Can you hear a pump humming when you activate the washer? Look in the under flooor compartment

Posted on Mar 22, 2009

jrw4u
  • 62 Answers

SOURCE: windshield washer fluid only trickles out doesnt spray

exactly what bob said you can use a needle to stick down in the holes and clean them out also you can adjust them with the needle on most cars by moving it up and down

Posted on May 01, 2009

  • 1 Answer

SOURCE: Windshield washer fluid pump quit. 2005 Jetta

I have a 2003 Jetta and the fuse box is between the dashboard and the drivers side door. There is a lid that covers it on the dashboard side. Inside there is a diagram/fuse card. The card has one top rectangular series of fuses numbered 8 through 23. Below is a square series numbered 24 through 44. The washer fuse is number 24 on the top left of the bottom square series. For me, I checked the fuse and it was good, therefore I am assuming that my pump is dead.

Posted on Jun 17, 2009

BuzzFlewhart
  • 655 Answers

SOURCE: Low Washer fluid warning light came on my Lexus

There is a little float mechanism inside the washer tank that is probably stuck or binding. If the wiper/washers work, you have power to the fluid tank.
Pull of the top and see if you can locate it. You might need a piece of flexible, fine wire to GENTLY help it along...

Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

In my 2007 Saturn Vue there is what I think is an air pump which is cracked that one port is not connected to anything.


There is a electric motor that pumps washer fluid . Located in the bottom of the washer fluid tank .
Wash Operation (Front and Rear Wipers)
The front and rear washer systems use the same windshield washer fluid pump. When either the front or rear wiper is in the washer position voltage will be supplied to one side of the windshield washer fluid pump (depending on whether it is front or rear), while the other side of the pump is grounded.
At this point, the windshield washer fluid pump sprays solvent onto the windshield. When the front or rear washer is activated, the BCM receives an input from the switch that is activated. The BCM will control the wipers while in the WASH mode. The BCM will control either the front wiper relay or the rear wiper relay to turn on the wipers. The windshield wipers operate at low speed for 3 swipes and returns to the park position.

When turning on the washers do you hear the motor run ? Have some one try it while you listen at the washer fluid tank ! These pump motors do go bad .
turn OFF the ignition.
Disconnect the harness electrical connector of the windshield washer fluid pump.
Connect a test lamp from the windshield washer pump control circuit to a good ground .
Turn ON the ignition, with the engine OFF.
Press the front washer switch.
Does the test lamp illuminate?
YES or NO !

Nov 18, 2016 | Saturn Cars & Trucks

Tip

Adding windshield washer fluid to Buick Lacrosse 2005


When the windshield washer fluid is low, a low washer fluid light may appear on the instrument panel cluster. In addition, if your vehicle is equipped with a Driver Information Center (DIC), the LOW WASHER FLUID message will appear when the fluid level is low. When you need windshield washer fluid, be sure to read the manufactures instructions before use. If you will be operating your vehicle in an area where the temperature may fall bellow freezing, use a fluid that has sufficient protection against freezing.

on Oct 08, 2010 | Buick LaCrosse Cars & Trucks

1 Answer

Where do I put windshield fluid in on a 2004 montero


Here's a video showing you how to add windshield fluid,will make you watch a commercial,lol. Add Windshield Washer Fluid Mitsubishi Montero Sport 1997 2004 1997...

Aug 10, 2015 | 2004 Mitsubishi Montero Sport

1 Answer

2012 windshield washer fluid low light came on but when I filled the fluid the light did not go out


A 2012 should be under warranty . These cars have to be scanned when lights come on usually because of their computers. It could be as simple as a reset, but I would take it to the dealer, or try running the fluid low purposely, and filling it up again as they may have a float inside the washer resevior sticking, Toyota is good to fix their customers up, if all else fails, I would bring it in. Hope this was helpful

Jan 02, 2013 | Toyota Camry Cars & Trucks

1 Answer

How do I replace the windshield washer low fluid sensor. The low windshield washer fluid light is on and will not go off even though the washer fluid tank is full.


That sensor can be replaced. It's located on the washer fluid bottle which is found behind the front bumper and next to the passenger's fender.

Jan 25, 2011 | 2003 Honda Odyssey

1 Answer

In the Info Center far right hand side a light came on today


I believe this is your windshield washer fluid light. Under the hood, you should find the cap with the same symbol. Put some windshield washer fluid in the tank and the light should go away.

Hope this helps,

Jeff

Jul 05, 2009 | 2001 Dodge Dakota

1 Answer

1997 Lincoln Town Car washer fluid light on panel.


replace fluid tank. might find it cheap in a junkyard

Apr 01, 2009 | 1997 Lincoln Town Car

1 Answer

Have a light on dashboard that looks like windshield wipers


Check your windshield washer fluid level.  The washer fluid tank has a level sensor in it.  That could be why that light came on. 

Jan 31, 2009 | 2003 Toyota Camry

3 Answers

Windshield washer Pump doesn't run, but the pump checks out good


there is another small relay box just below the windshield washer reservoir about 11/2" wide x about 4" long the washer pump relay is in there



Nov 23, 2008 | 1999 Ford Explorer

Not finding what you are looking for?
1999 Dodge Intrepid Logo

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...