Question about 1993 Toyota Camry V6

3 Answers

My 1993 toyota camry v6 wont start

Car tries to start wont turn over. i checked diagnostic it flashed once paused flashed twice. changed plugs and wires are fairly new changed distributor cap and rotor still not getting a spark at plug. checked ignition module and it was fine.dont no what else to do. any help would be appreciated

Posted by on

  • um_ed Jul 26, 2009

    thew fan works when i try to start car.i checked all fuses but still no power to distributor

  • um_ed Jul 27, 2009

    the engine turns but wont start.battery and starter are fine fuel pump is fine all fuses okay

×

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

If the engine wont turn over check the battery if good check starter may be bad starter motor.

Posted on Jul 26, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 164 Answers

How the starter. Hows the mass air flow censor those things alos affect the starting of a car.
Hows the fuel pump alos
What was the last time it did run how did it run was it doing any thing funny?
auto zone has pocket pc you can rent out ore if the car worked that checks the codes see what wrong narrow down to a section to figure it out. Wally world aslo sells them.

Posted on Jul 26, 2009

  • The Bad Chad Jul 27, 2009

    Go auto zone rent one out the pock pc that reads your computer codes for the car. Wallmart sells them also
    Have mass air flow sensor checked out and there might be some other sencors that can cause it not turn over my jeep had 3 items.
    i always find good go service writers at the dealers chat them did you try do a google search Put 93 camray will not turn over what things can be wrong. Hanes books are helpfull in this area to.
    its normal battire and starter that go bad did you have them pulled out checked. How about does your car have EGR vaule those also go bad i think that what wrong in my moms.
    Replace the EGR valve and tell me that not it.
    This happen on my friends ford



×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 135 Answers

Are you sure your battery is fully charged and also that your starter is operational? If the motor is not cranking over that would be the first place to start looking.

Posted on Jul 26, 2009

  • Kenneth Jolley Jul 27, 2009

    I still do not know if the engine is actually turning over when you turn the key to start. The engine should crank over if the starter and battery are functional, regardless whether or not there is power to the distributor.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93' toyota camry takes to long to warm up in the


Sounds like a dead spark plug or faulty wire, or even out of time. Start with changing plugs. No change, do the wires. No change check the timing belt. It may have jumped a cog. As for the slow to warm up part, the misfire won't help that problem, but you may need to change the thermostat if it doesn't improve once you get it running on all cylinders.

Feb 05, 2012 | 1993 Toyota Camry V6

3 Answers

Check engine light just came on 1993 toy camry


First you need to find out what the fault code is that is making the check engine light come on. To do this, locate the diagnostic connector under the hood. It will be a black rectangular connector approx 50mm X 25mm with Diagnostic written on the cover. Open the cover and on the inside of the cover will be a diagram of the connections and their different labels. Locate pins labelled TE1 and E1. Switch on the ignition switch without starting the engine and with a small jumper wire bridge between pin TE1 and pin E1. Observe the check engine light on the dash and you will notice that it will be flashing. Read the diagnosis code as indicated by the number of flashes that this light makes. Each code will be displayed by first blinking the first digit of the code, then a pause and blink the second digit of the code. For example, Code 52 (knock sensor signal) will flash 5 times, pause and then flash 2 times, then a longer pause before it goes onto the next fault code if there is another one. Once it has gone through all the stored fault codes it will go through the sequence again starting at the first fault code again. Due to the many different fault codes that can be obtained it would be better to post another question for the fault code obtained. Good luck!

Jan 06, 2010 | 1993 Toyota Camry V6

1 Answer

1993 toyota camry v6 (not the fuel system) wont


Yes.......I fixed it for now....EFI relay. after putting in a new fuel pump$ 200.00 later and another relay $ 40.00 for next day delivery.I inserted my friends relay into my car....burmmmmmmmm..$ 30.00 and fine...
what a Pain.In.The.A..................................................................................

Nov 28, 2009 | 1993 Toyota Camry V6

2 Answers

Toyota Camry 1993 vibration during driving position


So you're saying it starts to shake as soon as you put it in gear? If so, you probably have a dead spark plug or plug wire, or disconnected plug wire. It could be something more serious. Head gasket, cam shaft, timing chain. Try the plugs and wires first, and go from there.

Apr 28, 2009 | 1993 Toyota Camry V6

1 Answer

1993 Toyota Camry Engine light comes on start panel


There is usually a diagnostic box when u raise the bonnet. It is located at the passenger side, close to the body of the vehicle. If u open it, u will notice that there r 2 points E1 & TE1. Bridge those two and observe how the engine light flashes, ie how often after pauses. The blink between pauses represents a digit. Remember it and tell me what number u ended up with

Nov 12, 2008 | 1993 Toyota Camry V6

1 Answer

1993 Camry Check Engine Light


Therre is no DTC code "5". The DTCs start at 12. If the knock sensor (there are actually 2) was bad, you would have an acceleration issue. The knock sensor changes the timing of the spark to eliminate detonation, or "pinging". Do you have a "Ping" condition/valve rattle on acceleration?
To reset the light, open the hood, remove the 15 amp EFI fuse for 5 minutes. Replace it, and start the car and drive it until it reaches operating temperature. If the light comes back on instantly, you have a bad sensor or a bad wire.

Nov 09, 2008 | 1993 Toyota Camry V6

2 Answers

1993 toyota camry turn check engine light off


Open the hood. Locate a small grey box by the firewall, roughly 1.5 x 1.5 inches. It has a cap that will lift up, but it will not come off. Under the cap, located the terminals E1 and Te1. Using a standard paper clip, "jump" E1 and Te1 together. Turn the key on. Obnserve the check engine light; it will flash, pause and flash again. Count the flashes.
Examples: 2 flashes/pause/4 flashes is code "24"
1 flash/pause/5 flashes is code "15"
Get the codes & get that info back to me so that I will be able to assist you with your issue further.

Oct 04, 2008 | 1994 Toyota Camry

5 Answers

1993 toyota camry 4 cylinder will not start


this kept happening to me and it was the erg valve.

Oct 03, 2008 | 1993 Toyota Camry V6

Not finding what you are looking for?
1993 Toyota Camry V6 Logo

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...