SOURCE: i am looking for a diagram of the 2005 4200 vortec
do not have a exploded veiw but if you look on top of the valve cover you will see 6 coils remove the coils and the plugs are under the them
SOURCE: boss performance chip installation
Where is the Intake Air Temperature Sensor or the (IAT)Sensor on a 2004 JEEP GRAND CHEROKEE LAREDO 4.0 .???
I Have A Boss Performance chip that i would like to install....Thank's..
SOURCE: how do I change o2 sensor on 2005 cobalt
Hi, place the Cobalt in "Park" on a level surface. Allow the Chevy to sit for 10 minutes. This will allow components to cool enough to touch but still be warm, which is ideal for replacing the oxygen sensor.
Open the hood of the Cobalt and identify the oxygen sensor. Look for a white, rubber, plug-type sensor on the passenger side of the exhaust manifold; this is the oxygen sensor.
Use a socket wrench paired with an oxygen sensor socket to loosen the sensor. Turn the wrench counter-clockwise until the oxygen sensor is loose. Remove the sensor from the manifold by pulling it off. The sensor will come off without much force.
Insert the replacement oxygen sensor onto the manifold. Secure the sensor by pushing it into place until the sensor clicks. Close the hood of the Cobalt.
Take care
SOURCE: Where is the MAP sensor
Hi, there are 3 different engines for the 2005 Cobalt. I have pasted instructions from Autozone.com for all 3 below. I recommend you run the test also pasted below before buying a new sensor. If your sensor passes the test, please get back to me with your symptoms and/or trouble code for alternate repair advice. Please let me know if you have any questions, and thanks for using FixYa.
Fig. Manifold Absolute Pressure (MAP) SCIP sensor location-2.0L engine
Fig. Manifold Absolute Pressure (MAP) TMAP sensor location-2.0L engine
Fig. Manifold Absolute Pressure (MAP) sensor location-2.2L & 2.4L engines
Fig. Manifold Absolute Pressure (MAP) connector end view-2.0L & 2.2L engines
Fig. Manifold Absolute Pressure (MAP) connector end view-2.4L engine
Removal & Installation2.0L Engine
Supercharger Inlet Pressure (Scip) Sensor
WARNING: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.
To install:
NOTE: Use the new SCIP sensor seal provided with the new SCIP sensor.
Temperature Manifold Absolute Pressure (Tmap) Sensor
To install:
WARNING: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.
NOTE: Use the new TMAP sensor seal provided with the new TMAP sensor.
2.2L & 2.4L Engines
To install:
Testing
Any damage to, or hairline fractures of, the MAP sensor housing,
Loose or improper installation,
Any vacuum leak
Circuit Testing
NOTE
All electrical components and accessories must be turned OFF, and allowed to power down.
Component Testing
NOTE
You must perform the circuit/system testing, in order to verify
the integrity of the MAP sensor circuits, before proceeding with the
component testing.
Its usually in the side of your thermostat housing. has a 2 or 3 wire plug hooked to it
297 views
Usually answered in minutes!
×