Question about 1993 Chevrolet S-10 Blazer

1 Answer

The eng. Run Great ,no problems until the Eng. warms a bit sometimes this only takes a fesw min.then it runs rough for a few min. then it dies and wont start back. till the next day. the problem began ,eng. ran for a couple of miles then quit. I've changed all the ovious. Like plugs,wires, Tps,map S. fuel filter ,Air Flt.Ect. I am in a tough spot,and on foot.

Posted by on

  • Richard Scordino May 11, 2010

    checked temp sender and mass air flow sensor?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 36 Answers

Ign. module needs replacement.Very common problem.Be sure that you use the dielectric grease on thenew part,also do not wipe off the old grease completly just smooth it out.

Posted on Jul 26, 2009

  • jimmy crossan Jul 26, 2009

    ign. module needs replacement.Very common problem.Be sure that you use the dielectric grease on thenew part,also do not wipe off the old grease completly just smooth it out.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 387 isx pete start might run 1 min might run 25 min ck eng light stop eng light comes on dies cycle key it will start right back up same thing


could be a weak fuel pump or regulator fault (fuel) faulty relay pump/injection ether one. idle valve sticking. these will all need to be checked.

Oct 09, 2013 | Cars & Trucks

1 Answer

Eng. will idle &run rough.Restart and it runs fine./19872.8/V-6


if it has MAF & TPS sensors then clean with right cleaners and check air filter your computer is resetting itself

Apr 21, 2012 | 1987 GMC S-15 Pickup

1 Answer

Jumping out of gear after eng gett up to running temp . backfiring & running ruff on low end after eng warms uo


Probably need to change the transmission filter and run some stop slip through it. The rough running and backfiring can be a few different things. It'll help me answer your problem if you'll tell me a little more about the jeep. What year is it? What engine is in it? How long has it been since the last tune up?

Jun 18, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Fuel pump started making noise. Replace it 3 times,noise returns after a short time


my 2003 grand caravan 3.3l run for 30 then daying and fuel pump making noise you can restart again it run for 2 to 3 min dies again pep boys change crank sensor fuel pump no help when eng shutdown middle of high way or trafic no fuel to eng does have elect power no eng check light any help

my e-mail is mqur1963@aol.com

Nov 09, 2010 | 2003 Dodge Caravan

1 Answer

Code 44 1990 suburban eng constantly on after new o2 installation in morning starts rough,drive a few blocks its ok.go to the store let car sit 15-30 min restart does same thing stummbles for few blks once...


there are 11 representations of code 44 but basically the exhaust is lean, and/or idle switch open- adjustment, and/or exhaust gas recirculation, pulse width modulation error. Hope that helps.

Apr 29, 2009 | 1990 Chevrolet Suburban

1 Answer

SERV ENG LIGHT/tough start in cold 96 OLDS CUTLASS SUPREME


Go To A Local Auto Zone, Since Your Serv Engine Light Is Illuminated They Can hook Up To your Diagnostic and the car will tell them whats wrong.
Also A Really Big plus Its FREE

Jan 19, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

Eng. dies just like you turn off swich starts backup runs great


Check the roll over protection switch. Make certain that the connection is good and not corroded.
RPM Northwest

Jan 17, 2009 | 2000 Jeep Grand Cherokee

1 Answer

RUNS ROUGH STALLS CHECK ENG LIGHT ON


The plug is located at the bottom of the steering column.The fault seems to be the mass air meter though.

Nov 26, 2008 | 1994 Volkswagen Golf

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...