Question about 2003 GMC Yukon Denali

1 Answer

My left rear tail light won't stay on when my lights are on but it will work when I brake. How do I fix that issue

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 163 Answers

Need to change the bulb with two filamente in it one is bad

Posted on Jul 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace left rear brake light bulb


1) Open trunk
2) Remove small round plastic access panel with a flat tip screw driver by prying open
3) Remove flat tip screw holding tail light assembly
4) Remove tail light assembly by pulling outward, careful not to break plastic guide/nub
5) Disconnect wiring connectors
6) Remove plastic housing access plate on back of tail light assembly by twisting/turning tabs until they click and then lift access plate from tail light assembly
7) When viewing the the bulbs, the turn signal bulb is the bottom left bulb
8) Install in reverse order, ensuring tail light seal seats properly during installation

Oct 13, 2014 | 1999 Audi A4

1 Answer

Rear lights issue


reverse lights are on a different circuit to the brake/tail/clearance lights. Check fuses for the others.

Aug 26, 2013 | GMC Suburban Cars & Trucks

2 Answers

2007 chevy impala brake light and left turn signal not working


Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Aug 07, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Left turn signal won't work, light bulbs are good, fuse is good. when the emgency flasher is on only the right will blink. The singal will turn on and stay on without blinking when the brake petal is...


Replace the circuit board on the left rear tail light ***.This can be purchased at a NAPA auto parts store.(this is where the bulbs are fasten into)

Oct 25, 2011 | 2004 Chevrolet Tahoe

1 Answer

I replaced a cracked rear tail light with an after market new light. Now the brake light won't work but reverse lights and directional signal do. The bulbs are fine as I've moved them around and...



  • If there are no brake lights period the check the stop switch (brake light switch)
  • This is attached to the upper part of the brake pedal itself. Should be a little wire off of it. When that goes bad the brake lights will not work at all.
  • Please note that the fuse for "brakes" is ABS only and has no bearing on the brake lights themselves working.
Regards, Tony

May 30, 2011 | 2003 Jeep Grand Cherokee

1 Answer

Rear brake lights don't work


you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

May 23, 2009 | 2005 Chevrolet Silverado 2500HD 2WD

2 Answers

2001 Explorer Sport ,Rear Driver Brake Light and Turn Sig. Broke


Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have power there when brakes or turn signals are activated. Or just try another bulb.

Feb 12, 2009 | 2001 Ford Explorer Sport

1 Answer

96 Ford Contour - The Classic Rear Brake lights don't work...


no disrespect but....
Check the book and make sure you are using the proper bulbs on all sides. (3957 looks just like 3956 but wont work right)

Jan 23, 2009 | 1996 Ford Contour

1 Answer

2006 Chevy Trailblazer Tail Lights


There was a recall on this, take to the dealer and they will replace the whole socket on this.

Nov 06, 2008 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
2003 GMC Yukon Denali Logo

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...