Question about Lexus ES 300

1 Answer

Fog light keeps going out, replaced bulb, it worked for a few da

Fog light keeps going out, replaced bulb, did it again, light is on the passangers side of that matters, 1995, lexus es300

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 83 Answers

Make sure, there is no water intrusion. The fog light lens may have a pin hole or crack in it causing water intrusion.

Posted on Jul 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Silverado fog lights not working


use a volt meter to see if the lights are getting power to the bulb sockets
and sometimes if you touch the bulbs the oil on your fingers will cause them to burn out if you touch the bulbs always wipe them clean before you turn them on

Jan 29, 2014 | Cars & Trucks

1 Answer

My passanger side break light will not work......


The light bulb has 2 operations, brake and tail lights. Go to Advance and they will replace it for you.

Feb 18, 2013 | 1999 Chevrolet Malibu

1 Answer

Fog lamps on 2004 Tahoe won't come on.


You need to check the bulbs.These are known to go out a lot.Also you can check that you have power to the lights with a test light.Sounds like a bulb or wiring problem.I have had a few of these that are broken off because they are so close to the ground.Depending on if your four wheeling or in snow country.Hope this helps.Good luck.

Feb 16, 2012 | Chevrolet Tahoe Cars & Trucks

1 Answer

Foglight does not go on how do I replace bulb


u must get under the front bumper, the fog light bulbs are replaced from the back, do not touch these bulbs when installing ot they will crack the 1st time u trurn the fogs on for more than a few minutes

Apr 22, 2010 | 2005 Dodge Neon

1 Answer

I installed HID headlights and fog lights about 2 months ago and the passanger side went out. i took the drivers side bulb and put it into the passanger side to see if the bulb or the ballast was bad and...


The headlights run through a relay (#46) through the BCM. If the relay were bad (very common and has a recall) both lights would not work. Sooo, I'm thinking check the wiring and pigtail that goes to the bulb. People that use Silverstar halogeon bulbs will burn that wire and or the connector. Make sure these are sound, check for power at the connector too.

Apr 17, 2017 | 2007 Chevrolet TrailBlazer SS

3 Answers

Directions for replacing fog lamp bulb on 2005 hyundai xg350


first start by popping the hood then removing the gray caps covering ether the low beam or high beam depending on witch your replacing these are located on the right front by the battery and left front by the windshield fluid reserve then undo the metal clamp securing the bulb then carefully remove the bulb keeping in mint to only attempt this after the bulb has cool because they get extremely hot and never touch the bulb if you plan on using then again after that disconnect the wire harness from the bulb then take your new bulb and it will plug right in.WARNING HID BULBS WILL NOT WORK OR CONNECT PROPERLY IF YOU DON'T HAVE A COMPLETE HID KIT.

Aug 12, 2009 | Hyundai Motor 2005 XG350

1 Answer

The dash board lights are not working and the


hi mate if you keep blowing fuses disconnect your front fog lights and try again if your dash lights work then a bulb has failed and gone to earth if it still blows the fuse disconnect the dahs pod (clocks) and reconect the fog lights if it does not blow the fuse the it probably is the dash pod or something associated with the pod hope it helps

Apr 02, 2009 | 1994 Subaru Impreza

2 Answers

1992 acura integra tail light fuse keeps blowing


it sounds like the wiring is all wrong as if its a bad earth on the car after he wired the fog lights maybe you should check and see if there is any wires hanging down underneath the bonnet that have been stripped back or see if there is and loose wires on the back of your lights or fuse board if you dont find any problems there take out the radio in the car i find that most problems to do with bad wiring or electrical problems in cars is to do with bad wiring on a radio i.e not having been installed proberly. hopes this helps

Feb 19, 2009 | 1992 Honda Civic

1 Answer

Fog lights not working


first things first check your fuses for your fog lamps for any type of rust or corrosion and replace them, second check to see if a bulb is blown sometimes if 1 bulb is blown bolth lights wont work, and 3rd check the wires under the car for cuts or burns. if you have too replace them. if none of those work replace your foglamp on/off switch

Oct 18, 2008 | 2002 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

874 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...