Question about Jeep Grand Cherokee

1 Answer

2005 jeep cherokee won't turn over - security light on dash flashes constantly - relay clicks but no juice to solenoid wire

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 298 Answers

This vehicle is equipped with a factory alarm system i should deactivate with your remote switch or if you never used remote switch them the chip on the key remote is defective and you need a new key or reprogram the old key I hope this information has been useful good luck

Posted on Jul 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can a starter drop dead with no previous indications of it going bad?


Hi Frank , what make vehicle ? Do you have any warning lights lit on the dash , SECURITY maybe ? Check engine light ? Did you check to see if there is battery voltage at the starter solenoid ? Did you check if there is A starter relay ?

Apr 26, 2015 | Cars & Trucks

1 Answer

Clicking noise dash jeep grand cherokee


the clicking noise could be a relay trying to latch or a security system armed either way you have to have your BCM(body control module ) checked, le me know what is the diagnosis

Oct 14, 2013 | 2001 Jeep Grand Cherokee

1 Answer

98 cherokee turns over but won't start no power to wiring at fuel pump an on the dash ther is a orange key with a line throw it what does it mean


This indicator light is related to the vehicle security system, which checks that the key you are using is authentic. If it is flashing, you have a key with no chip in it, a bad ring antenna, or other fault in the security system.
Instructions
    • 1Turn the ignition switch off.
    • 2Insert the key into the driver's side door.
    • 3Turn the key clockwise to lock it.
    • 4Turn the key counterclockwise to unlock it. The alarm system recognizes an authorized key was used and the system resets.
      As a side note if that doesnt work try it in the rear hatch. good luck hope this helped.

Dec 01, 2011 | 1998 Jeep Cherokee

1 Answer

I Have a 94 cherokee country with a 56028297 ecu,it has no power at the grey wire at the ecu,it does flash sometimes and I can hear the relay work sometimes. I can bypass the fuel pump relay circuit and...


If you hear relays clicking sometimes and the jeep won't start, at those times, is the check engine light illuminated on the dash, or not? If no check engine light is on the dash, at times when the jeep won't start, your ecu is in need of repairs. The ecu sends power to the ignition and fuel relays and when the ecu starts to malfunction, the relays usually start clicking.

May 11, 2011 | Jeep Cherokee Cars & Trucks

3 Answers

1998 jeep grand cherokee will not start


Try resetting the asd "auto shut down fuse had a similar problem the jeep would crank but did not get spark or gas also check your fuel pump? and the asd relay may be bad it will prevent the jeep from getting no spark and will not fire some jeeps have security problems

Jun 25, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Crazy clicking/flashing lights


There is a bubble shaped sensor on you center dash near the windshield. It may be dirty, blocked, or broken. If you hear a high speed click and the lights strobe pretty quickly, it may be a bad relay. Last, you may have a bad ground. But - I doubt it since the lights work fine when not in Auto mode. I would start with the sensor then relay.

Apr 24, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...