Question about 1996 Jeep Grand Cherokee

1 Answer

My 97 Cherokee blows fuse #11

The fuse is listed as auto shutdown relay (oxygen sensor). It blows it everytime the car is running. What can be causing this? Also my Check engine light is on along with the car running rich.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 38 Answers

Change the sensor

Posted on Jul 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep grand cherokee oxygen sensor fuse keeps blowing but stops blowing as soon as i remove auto shutdown relay


The ASD relay supply's battery power to that fuse . The wiring from the fuse to the O2 sensor has a short to ground somewhere . Look at the O2 sensor ,these wires sometime's get loose from body attachment point's an melt on exhaust manifold's or exhaust pipes .

Nov 03, 2017 | Jeep Cars & Trucks

1 Answer

2007 ford freestar will fuse # 40 in the underhood fuse panel when the key is turned to the run/start position. It would blow before when it was running and cause vehicle not to shift. Had the transmission...


Any applicable trouble codes? Several systems get voltage off that same fuse. oxygen sensors-- canister purge solenoid--ac compressor relay--imrc, intake manifold runner control, has to do with induction-- breathing. And tranny control.
If it blows as soon as the key is turned on, maybe you can narrow it down by unplugging each system one at a time? That may not be conclusive, any system you unplug, there will be less amp draw on the fuse. Just a thought.

Jul 24, 2017 | Ford Cars & Trucks

1 Answer

30amp auto shutdown fuse blows is it alternater


The ASD relay supplies battery voltage (12+ volts) to the fuel injectors and ignition coil(s). With certain emissions packages it also supplies 12-volts to the oxygen sensor heating elements. The Fuel Pump Relay is a separate relay controlled by the ASD relay input to the PCM. Fuse #12 (10amp) provides 12 volts to the coil side of both the relays and the ignition switch. Fuse #6 (30 amps) supplies 12 volts to the output side of the relay. Fuse #16 (15 amp) from the relay output to the Oxygen Sensors and Fuse #26 (15 amp) relay output to the PCM. Fuse #24 (20 amp) is Fuel pump relay output to fuel pump. Fuse #19 (10 amp) supplies 12 volts direct to the PCM.
look for burned or melted wires in the offending circuit.
sounds like you wiggled a wire while installing new relay.

Mar 06, 2013 | Cars & Trucks

1 Answer

Check engine light on- auto zone scanner shows error code p0053 probable cause: 1.-check circuit fuse 2.-relay defective 3.-check circuit wiring Where are fuse and relay located?


The code P0053 is for your Bank 1 Oxygen Sensor, the closest Oxygen Sensor to the engine, connected to the Exhaust. Replace your Oxygen Sensor, clear the code, and see if it comes back.

Mar 12, 2011 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Vehicle will not start and stay running, the automatic shutdown relay fuse blows out right away.


automatic shutdown connection are, pcm C2#21 all fuel injectors, and heated oxygen sensors, check first the Ho2s sensors(4 pcs) located on exhaust pipe, look for burned-out

Jun 19, 2010 | 2000 Dodge Neon

1 Answer

What does fuse 11 control. labeled hblind


Should be the Power Control Module/Auto Shutdown Relay/Fuel Pump Relay...hope this helps. Good luck

Mar 02, 2010 | 2000 Jeep Grand Cherokee

1 Answer

97 jeep cherokee blows fuse #11


I think fuse 11 is transmission control module, powertrain control module, automatic shutdown relay, fuel pump relay.. most likely it could be an issue with the wirings from the tranny. Check this one out before opening the conduit

Jun 03, 2009 | 1996 Jeep Grand Cherokee

4 Answers

Jeep keeps blowing auto shutdown fuse


Yes I had the same problem. The wires that plug into the sensor at the catatytic converter were rubbing against the drive shaft untill they finally wore through causing the short against drive shaft. repaired wires and it fixed everything

Aug 22, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...