Need to remove the front bumper cover on 2006 buick lucerne

You might want to take it to the dealership....You won't believe me, but you have to remove the front bumper cover, then you have to remove the headlight capsule to get to the bulbs.

Follow the videos in this link. The third step is what you need.

most starter on these cars are in front radiator side #1 disconnect battery #2 jack up front of car enough to get beer belly under support with jack stands. then remove the two bolts that hold starter to engine block 15 mm bolts slide starter forward and rotate remove battery lead and starter signal lead 15mm and 8 or 9 or 10 mm nut you may have to remove dust cover on trans 2 10 mm bolts twist and swear it will come out then install in reverse order

I have replaced headlights on my 2006 Lucerne. I tried the cheater ways but there was no getting past taking the front end off. The front end is held together with plastic rivets (5ZLY9) from Grainger there are three screws 10mm that hold the lights in and two screws that hold the bumper up besides the rivets. Take it all off and the bumper comes off exposing the headlights. I replaced ALL the bulbs since there was so much work involved.

clear everything from the cover...remove all bolts on cover...replace with oem or gasket sealer. look up torque specs

not hard just a hassle to move everything!

What about the the cxs lucerne which is a 4.6 l motor on the rear water pump the pulley comes to the valve cover you have to pull that pulley out with a puller or what to get the valve cover off because this removing the cap ain't going to do it is that pulley goes all goes right through the valve cover and it don't just slide off very easily so how do you get it off. This is the picture of the front cylinder Bank the rear of it where the water pump belt holds up bolts on to you that's cool you there is what turns the water pump now how do you get that off yet we got to pull it off of the pool right

to fix this problem with my 2007 buick lucerne I had to take off the bumper and then remove the old seal on the body under this bumper and reseal it. it was not the trunk seal and nor was it coming from the lights or anything else. it was this seal that you cannot see unless you remove the bumper.

Remove air box & air tube loosen throttle body 2 clamps disconnect Hoses on pump area remove rear cover 4 10mm bolts from rear of pump disconnect two bolts on housing bottom then 4 bolts on center housing two more are on lower rear between eng & tranny the other two are front lower 8 total remove nut fuel line clamp disconnect Wiring move housing out pump area 2-3 inch disconnect tensioner & remove water pump 5 x 10 mm bolts install new pump & reassemble good look 2-3 hours

you may have a blown bulb. Believe it or not, Buick recomends the removal of the front bumper facia in order to remove the headlight assembly to change the bulb. you can however remove the air box where the air filter is located and squeeze your hand in there and change the drivers side bulb. It's allmost imposible to change the passanger side however. Good Luck

I have read that the only way is to remove the plastic bumper. I hate my Lucerne...piece of junk.