Cars & Trucks Logo

Related Topics:

Lee Stahr Posted on May 28, 2017

Can't get out of aux 1 and no sound from radio

Ran over 8" curb its in a Ford F-150 what to check that may be loose

2 Related Answers

Dennis

  • 100 Answers
  • Posted on Dec 22, 2010

SOURCE: my truck have check engine

It is referring to the throttle/ pedal position sensor which is either located at the top of the gas pedal or on the throttle body. The code is pertaining to the sensor not having the correct voltage. You could have a loose connection or the sensor could be dirty or just faulty all together. You need to do hook up a digital multimeter and do a sweep by pressing the gas pedal and see if the voltage changes accordingly.

Ad

Anonymous

  • 1102 Answers
  • Posted on Aug 08, 2011

SOURCE: Where's the location for O2

Bank 1 is the side that has cylinder #1... Sensor 1 refers to the sensor that is BEFORE the catylitic convertor. On your vehicle it is the PASSENGER side.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Whining sound from front end

hi, if the sound comes from behind your wheels try checking the steering rack isnt loose also check the tracking rods, easiest way to check these are park your car tight against a curb and try and turn the steering wheel if your wheels are tight to the curb your steering shouldnt move. if the steering wheel can be moved your steering rack is loose. if the sound is more center to the engine your cambelt is slipping and needs adjusting or replacing.
tip

What is the firing order for Ford F-150 Ranger?

The firing order for Ford F-150 Ranger is as follows:-- {Ford F-150 Ranger 5.8L is :-- 1-3-7-2-6-5-4-8.} {Ford F-150 Ranger 5.0L is :-- 1-5-4-2-6-3-7-8.} ------- This will help.Thanks.
0helpful
2answers

My radio has an aux button but the car does not have a jack for aux play? am i looking in right place or do i have to have one installed?

07 Ranger and Mustang were the first vehicles to come with a factory installed aux jack. All prior vehicles had to have one installed. I believe the Ford kit was called Trip Tunes.
0helpful
1answer

1. my radio just stopped working, it used to go on and off depending on the dots in the road or a big bump but now there is nothing, the fuses are ok too. 2. the horn does not work at all, fuses are ok...

it sounds like the plug in the back of the radio has come loose. remove radio and check connection. as far as the horn PULL THE WIRE FROM THE HORN UNDER THE HOOD THEN RUN A TEST LEAD FROM THE + SIDE OF YOUR BATTERY TO THE HORN IF IT HONKS REPLACE THE HORN RELAY IF NOT REPLACE THE HORN. GOOD LUCK

If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_00678fd4800d19c5

1helpful
2answers

Help me how too set firing order

1999 Ford F 150 2WD Pickup 4.6 liter SOHC V-8 VIN "W"
or
1999 Ford F 150 2WD Pickup 4.6 liter SOHC V-8 VIN "6"

zjlimited_17.gif



1999 Ford F 150 4WD Pickup 5.4 liter V-8 Prop SOHC VIN "Z"
or
1999 Ford F 150 4WD Pickup 5.4 liter SOHC V-8 VIN "L"

zjlimited_18.gif



1999 Ford F 150 4WD Pickup 5.4 liter SOHC V-8 VIN "3"

zjlimited_19.gif


Hope this helps (remember to rate this).
0helpful
1answer

I have a 2001 f-150 the radio doesn,t work,i bought a used one off ebay,i also checked the fuses,still nothing

which fuse did you replace... the radio uses three!
you need to check fuse # 1, #8 and #20 in the CJB (central junction box) under the dash

assuming these are good then pull the radio out again and check for power at the radio pins number 3, 9 and 10

assuming these are good check your ground while you are there....use the test light with the good poser at the radio pin # 10 and then ground at the radio pins #2, 11 and 16
2helpful
2answers

Charging gauge bouncing back and forth starts after jump

sounds like a shorted field in the alternator
0helpful
3answers

Firing order

firing order is scribed on the intake of all ford engines
also silinders are numbered on the intake also
0helpful
1answer

Aux Audio button not working

it sounds like the radio is shot but i would take the truck to a shop and see what they have to say about it.
0helpful
1answer

HELP..ANY SUGGESTIONS

no there is no rca jack in the back of the radio you need a audio adapter call FRD04-AUX you can get one from partydown.com
Not finding what you are looking for?

23 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...