Question about 2001 Mazda 626

1 Answer

I have a 2001 mazda 626 and i have 96,000 miles now but ever since i hit 62,000 my car jerks bad when i accelerate and when i go over 60 mph it shakes also iv had it in the shop over 5 times for these problems and they keep saying its ok...is this my tranny?

Posted by on

  • amanda Jul 25, 2009

    ...i also forgot...when i turn on my my vents i have get up and go.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 14,036 Answers

TORQUE CONVERTER SHUDDERS THAT HAPPEN WHEN YOU HAVE STUCK CONVERTER CLUTCH. YOUR TRANSMISSION FLUID COULD BE LOW. OR DIRTY FILTER.YOUR TORQUE CONVERTER COULD HAVE INTERNAL DAMAGE.

Posted on Jul 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 town and country jerks over 40 mph to 60 or so mph


You could have a misfire ! ignition system problem . Is the vehicles check engine light on steady of flashing ? I suggest you take it an have it checked out . If it gets bad enough it could damage the catalytic converter , an that could cost up to a thousand bucks !

Sep 18, 2015 | Cars & Trucks

1 Answer

Why does my 2007 Chrysler 300 start to **** when accelerating around 60 mph and when I take my foot off the gas pedal? No brake was applied.


you need to check you plugs and wires on the car also looking into changing your fuel filter may be a great idea , just a normal tune-up on the car would help this out dramatically

Sep 30, 2014 | 2007 Chrysler 300

1 Answer

Backfire at 60 to 70 mph


Check for bad fuel, but it sounds like it might be spark plugs or spark plug wires breaking down and cross firing or missing. If it is electrical you should have a rougher idle also.

Sep 14, 2014 | 2001 Chevrolet Monte Carlo

1 Answer

Why is mybcm not letting me pass insp there is no code on thi1996 chry lhs what is going on


You mean PCM most states read the readiness monitors depending on the state on how many they allow not to be completed. The first one on the list that is hard to get run and pass is the EVAP Because this requires the car to be cold and fuel tank must between 15%-85% and both air temp and coolant temp with in 10 degrees of each other. Start car let idle for 5 -10 minutes Then drive car normally no hard accelerations or quick stops bring speed to 50-60 mph and coast down to 20-15 mph without brake pedal input repeat this twice.Then bring speed to 58-62 mph and set cruise control run for 12-16 miles exit freeway caught a red light or stop and idle 2 minutes shut car off rest for 5 minutes and repeat freeway drive. then redo morning cold start again . then have some one test the generic readiness monitors to what needs to run and attempt again. California before 2000 1 can be incomplete after 2000 all have to be completed which is hard some will not run for 800 miles.

Nov 08, 2013 | 2001 Ford Escape

1 Answer

2009 VW Routan car jerks when let off gas


Check Your Motor And Trans Mounts

Jul 04, 2013 | Cars & Trucks

1 Answer

I have a 1993 mazda 626 2.5litee 6 cylinder & when


transmission slipping could be torque converter. or tranny fluid. possibly gear teeth in tranny are ground down in one spot.

Dec 25, 2012 | Cars & Trucks

1 Answer

I recently purchased a 2001 Mazda Millenia. It was a little jerky test driving it, but it was winter with snow and ice. Now it's spring, and it's still jerky. I took it out on the hwy doing about 70 mph...


Do you notice does the problem seem to worsen in rain or humid weather? Try checking the MAF sensor it may just need to cleaned it can cause problems like this. Be sure to use MAF cleaner nothing else. The sensor may also be bad but try cleaning it first, its cheap and only takes about ten minutes.

Apr 07, 2011 | 2001 Mazda Millenia

1 Answer

I have a 2006 Hyundai Matrix 1.6 GSI petrol. Automatic. When cruising at 4o mph it starts jerking and seems like it has a problem selecting the right gear. Also at around 60 mph it jerks when I accelerate.


My experience with Hyundai vehicles strongly suggests you have a bad TPS (Throttle Position Sensor). Replace it... see if that CURES it. (OR, you can have a qualified technician bench test it to see if it is defective). Your solution.

Oct 01, 2009 | Hyundai Motor S Cars & Trucks

1 Answer

Vehicle does a quick **** when driving - on occassion


possibly the bearing is going inside your distributor. see htis site for photos & files

http://autos.groups.yahoo.com/group/villagerquest/

Feb 25, 2009 | 2001 Mercury Villager

Not finding what you are looking for?
2001 Mazda 626 Logo

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...