Question about 2003 Pontiac Grand Am

1 Answer

Installing new head lamps in a 2003 Pontiac Grand Am

What is the procedure for removing burned out head lamps? What "panels" and etc. do I need to remove and in what steps?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 61 Answers

It varies a bit from car to car, but generally you can pop the hood and see right where the wires go into the back of the headlight lens. Most have a tab that you press, then rotate the assembly to remove. Then, you can just plug the new bulb in and reverse the process. Most work that way.

Posted on Jul 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring diagram for headlights 2008 pontiac grand prix


I hate mices to pieces . You can get free wiring diagrams at www.bbbind.com click on technical information . Five box will pop up , click tsb's an free wiring diagrams . Next page go to the bottom an click on I agree. Then next page click on wiring diagrams an then enter your vehicle info , year , make , model , etc... then under system click on lighting , then subsystem click head lamps .

Nov 22, 2015 | Pontiac Cars & Trucks

1 Answer

How to change the freeze plugs in a 2001 Chrysler Grand Voyager 3.3l (aka Town And Country) - can this be done without taking the engine out ?


this can be done without engine removal. you will need a frost plug install tool with a movable head to get the angle to knock in the frost plug your installing. the procedure is the same weather its a grand or just a regular caravan.

Mar 02, 2015 | Dodge Cars & Trucks

1 Answer

How do I replace 2004 Pontiac Vibe passenger side tail light assembly?


Hello Tim.

Here is the procedure.
  1. Open the rear compartment lid.
  2. Remove the rear compartment trim panel (4).
  3. Remove the tail lamp socket (2) from the tail lamp(7).
  4. Remove the tail lampbulb (1) from the lamp socket (2).
kiltylake_125.gif


There you are, Happy New year.

KL

Jan 01, 2011 | 2004 Pontiac Vibe

1 Answer

Fog lights do not come on either when using headlights or with the fog lamp switch in my 2002 Grand Am SE. Fuse seems to be fine.


REPLACE THE FOG LAMP SWITCH DOWN ON THE STEERING COLM. REMOVE THE PROTEC. PANEL UNDER STEERING COLM. AND GENTLY START TO LOWER THE COLM. WATCH OUT FOR THE SHIFT IND. WIRE- REMOVE IT- LOWER COLM. AND HALF WAH DOWN ON THE TOP SIDE IS THE SWITCH FOR THE FOG LAMP CONTROL IF YOU HAVE ALREADY REPLACED THE ELEC. SWITCH - (PUSH BUTTON OR ROCKER STYLE ).IN THE DASH. IF - - LIGHTS AREON AND THE FOG LAMPS ARE TURNED ON AND THE HEAD LIGHT GO OUT OR WONT CHANGE FROM DIM TO BRIGHT REPLACE HIGH/LOW SWITCH ON COLM. SAME PROCEDURE AS FOG CONTOL SWITCH.

Nov 05, 2009 | Pontiac Grand Am Cars & Trucks

1 Answer

How do you replace the tail light bulbs on a 2006 Pontiac Vibe


Tail Lamp: Service and Repair
TAIL LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Open the rear compartment lid.
2. Remove the rear compartment trim panel (4).
3. Disconnect the tail lamp electrical connectors.
4. Remove the following components from the vehicle:
- The 3 nuts (3)
- The tail lamp (7)
5. Remove the following from the tail lamp:
- The stop lamp socket (2)
- The turn signal lamp socket (5)
6. Remove the following from the lamp sockets, if necessary:
- The stop lamp bulb (1)
- The turn signal lamp bulb (6)
INSTALLATION PROCEDURE
1. Install the following to the lamp sockets, if removed:
- The stop lamp bulb (1)
- The turn signal lamp bulb (6)
2. Install the following to the tail lamp:
- The stop lamp socket (2)
- The turn signal lamp socket (5)
3. Install the tail lamp (7) to the vehicle. Secure the tail lamp (7) with the 3 nuts (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the tail lamp nuts to 10 N.m (89 lb in).
4. Connect the tail lamp electrical connectors.
5. Install the rear compartment trim panel (4) to the vehicle.
6. Close the rear compartment lid.

Oct 30, 2009 | 2003 Pontiac Vibe

1 Answer

Security light comes on intermintently then car will not start for ten minutes it will do this quite often for awhile then will quit for a long time any ideas that don't cost more than the car is worth?


I have a Technical Service Bulletin. I'll even hand copy it from my program.

TECHNICAL

Engine stalls, Security Lamp illuminated, DTCs (Replace Theft Deterrent Control Module)

Models:
2000-2003 Pontiac Grand Prix built prior to Vin Breakpoint 3F115058

Condition

Some customers may comment that the vehicle starts then stalls and the security lamp is illuminated. These symptoms may be intermittent and after several attempts, the vehicle may stay running.

Cause

The condition may be caused by either a chafed wire in the theft deterrent module wiring harness or an electrical interference within the theft deterrent module not allowing the fuel enable signal to be detected.

Correction

Replace the theft deterrent module with Part No. 10335045 and reroute the module wiring harness to a new location using the procedure listed below.

1 Reroute the module harness on the outside of the steering column channel and tie strap the lower portion to the larger ignition bundle.

2. Replace the tie strap removed from the tilt head during disassembly. Secure the new strap in the hole in the tilt mechanism and around the module wire and ignition SIR wires, but below the tie strap located on the sir wires.


Jul 29, 2009 | 2002 Pontiac Grand Prix

1 Answer

How to change tail light bulb in 2003 lincoln ls


I can provide 2002, don't have 2003. may be similar. please rate as solveed problem if this is what you needed.

SECTION 417-01: Exterior Lighting 2002 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Lamp Assembly —Rear Removal and Installation
  1. Remove the luggage compartment door trim panel.
    1. Remove the 13 pin-type retainers.
    1. Remove the luggage compartment door trim panel.
93ced34.gif
  1. Remove the rear lamp assembly.
    1. Disconnect the electrical connectors.
    1. Remove the nuts.
    1. Remove the rear lamp assembly.
    • If necessary, install new bulbs.
5f6d88b.gif
  1. To install, reverse the removal procedure.

Mar 22, 2009 | 2003 Lincoln LS

1 Answer

Changing head lamp 04 grand am


you need gloves hands cant touch bulbs .oils from hand causes bulb to blow.to change bulb you raise hood remove head light housing has to be removed before you remove bulb.

Mar 07, 2009 | 2004 Pontiac Grand Am

5 Answers

Diagram on a pontiac grand prix


I have 07 Pontiac Grand Prix, the wrong key was inserted into the ignition the other day. Now when I try to use the correct key it will not insert completly in the ignition, goes in until last 1/4in of key. Im stuck, I bought the new lock cylinder but how do I get the old one out? I cant get the key to insert all the way so I cant get it to the "On" position, it will not turn at all. The key that was inserted in error is whole and nothing is missing it seems like there is something stuck. Any help would be appreciated...

Sep 09, 2008 | 2000 Pontiac Grand Prix

1 Answer

Head light bulb


OPEN THE HOOD, THE BULB IS HELD IN PLACE BY A ROUND TWIST TO LOCK/UNLOCK RETAINER, PULL THAT BACK AND REMOVE THE BULB BY WIGGLING IT AND PULLING STRAIGHT BACK.
CAUTION, DON'T TOUCH THE NEW BULB, IT WILL BREAK SOON AFTER YOU TURN IT ON FORM THE OIL ON YOUR SKIN, IF YOU DO TOUCH IT CLEAN IT OFF WITH RUBBING ALCOHOL.

Aug 13, 2008 | 2003 Pontiac Grand Am

Not finding what you are looking for?
2003 Pontiac Grand Am Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...