Question about GMC Envoy

1 Answer

When i put on the ac with the engine runing it would make the jeep cut out so i check the gas wax out all the gas and now it is not taking any gas at all what can cause that to happen.

Posted by on

  • Leonard Williams May 11, 2010

    please make your compliant more plain to understand.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 105 Answers

Perform a simple diagnostic scan that will give you the proper troubleshooting codes.

Posted on Jul 26, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jeep is burning gas really fast, what can be causing this?

You might want to check the wires that go to the 02 sensor it sounds like when the tune up was done the wires may of become dis-connected. Unless of course the tune up was done to correct the problem. In that case first check for gas leak under car and around gas tank, if OK then, next ( I take it there's no check engine light on) borrow a fuel pressure tester from Auto Zone and test the fuel pressure After you've hooked up the tester run the engine a few minutes then shut it off and watch the gauge it it slowly drops you more then likely have a leaking fuel injector.If in fact this is the case, before you replace the injector run the fuel down to 1/4 tank and add a good fuel injector cleaner to the gas and run until close to empty. Put fuel in tank and drive at least 50 miles to allow fuel system to clean out. If still the same then the injector is bad. Note; You could also have a bad 02 sensor but that should set the check engine light.

Mar 14, 2013 | Jeep Grand Cherokee Cars & Trucks

1 Answer

1995 jeep wrangler 2.5 i have no power.I ran out of gas in a mud hole the water was up to the doors i put gas in it and got out .I put in a new 02sen,spark plugs & wires buttin cap both trottel body...

I would run a compression check and bleed test to see if you have a weak cylinder due to a cracked head or bad valve...if you sucked some water in the intake or through the exhaust it could of done some internal engine damage.

Aug 06, 2011 | 1995 Jeep Wrangler

2 Answers

My jeep liberty was runing fine than it stoped runing and would not start till i pumped the gas pedel than would only run fro about for 40 seconds and than had to pump the gas to get it to run. This is the...

if your pumping the gas pedal,your only giving it more air not fuel,the injectors are doing the fuel,what is the temperature there when this happened and was this a cold start or a warm engine start.

Jan 11, 2010 | 2003 Jeep Liberty

1 Answer

After going 5 or 6 miles jeep starts kickin back .

could be many things, it could be looseing fuel preasure or coil spark gets weak or bad plug wires,

Dec 13, 2009 | 1995 Jeep Wrangler

3 Answers

My gas mileage went from 18 to 13mpg for no apparent reason. No indicator lights or computer information. I had the plugs changed and still the same. Suggestions?

Look at the gas pump and see what additives they are putting in the gas. They cut down the gas with 10% of something for the winter and a lot of cars don't like the cut although it will seem to run fine. Add an additive to clean your injectors also-the good stuff. Hope this helps. One other thing check your air filter. Restriction there will cut your mileage.

Oct 17, 2009 | 2006 Chevrolet Silverado 1500 2WD

1 Answer

1999 jeep wrangler guages went crazy

Put a volt meter on the battery itself and take a reading when it is doing that. If charge rate is over 14v the alternator may be working but the output is not being cut down to "useful voltage" You may have a regulator problem.

Jun 23, 2009 | 1999 Jeep Wrangler

2 Answers

2002 Jeep Wrangler 4.0 When Driving the Engine Dies

Put the key in the ignition and turn it on and off (3) times without starting the jeep, leaving it in the on position count the (1) flashing indicator Light, Eg: (5) flashes, Then there will be a pause, then it may flash (3) times, this is a code #53. Keep your Eye on them and write them down. If you should miss (1) Repeat as many times as needed, Info: A #55 means there are no codes!!

May 30, 2009 | 2002 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides