Question about Buick Century

1 Answer

The indicator lights won't flash, just stays on .

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Buick Master
  • 2,007 Answers

You probably have a bulb burnt out, either front or back, or a wire broken, or the flasher is faulty.

Posted on Jul 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have 2001kia rio. Cranks and idles great but when put in drive and start somewhere if ck engine light blinks car loses power but if light stays on runs ok.What's happeninng.


there is a code in the computer that needs to be checked out. if the light is flashing then its indicating the problem can cause damage to the motor or the catalytic converter and requires immediate attention when the light is on steady there is a code that again needs to be checked out but it won`t cause damage right away. either way get it checked out and repaired.

Aug 05, 2014 | Cars & Trucks

1 Answer

Flashing indicators on my audi a3 dont flash but stay on constant


change it. most likely contains the flasher for turn signal also

Jun 03, 2014 | Audi A3 Cars & Trucks

1 Answer

Turn signal light right flash


flasher/blinker is busted. this is located under your dash board. remove steering column cover, turn on LEFT turn signal (yes, the one that is working), then you will hear a clicking sound. locate the relay that causes the sound. there you can see 2 relays (one for LEFT, other one for RIGHT turn),replace busted one.

Jun 11, 2013 | 2002 Toyota Tundra

1 Answer

Citron xsara Picasso won't start and battery light stays on


Most of the time, this is an indication that the alternator is not charging the battery enough...could be loose or worn out belt?

Mar 18, 2013 | Cars & Trucks

1 Answer

Directional signals won't flash on a 1992 Buick century


Have you checked or replaced the flasher unit ?
Are all of the bulbs front and rear coming on ?

Jan 29, 2013 | 1992 Buick Century

1 Answer

Security light flashing, car won't start for infiniti


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 18, 2012 | Infiniti M35 Cars & Trucks

1 Answer

High beam lights flash, but won't stay on.Perhaps a blown fuse?


check the looseness between bulb and connector. blown fuse, lights are totally out.

Aug 17, 2012 | Cadillac Brougham Cars & Trucks

1 Answer

My indicater lights stay on an don't flash. What


get as new relay swich box and it should be ok if it dose not work check the steering indicator is not broken of inside the switch on the indicator arm

May 09, 2012 | 1982 Toyota Toyota Cressida

1 Answer

2000 pontiac sunfire headlights won't turn off DRL relay just changed, lights still on. removing fuses shuts them off. high beams will not stay on but flash when switched. DRL indicator light inside...


Hello and welcome to Fixya!

As a first course of action, I strongly suggest that you remove the positive batter connector and let it sit for atleast 5mins. before reconnecting it. This will reset the system and can get your vehicle back to it's normal operation.

Please do keep me posted on the progress. I'll be glad to help you out. Hope this helps and thank you for using Fixya! Have a good one!

Sep 04, 2011 | 2001 Pontiac Grand Am SE

1 Answer

I have a 1999 dodge caravan. Passenger sign turn signal flashes for a short period & goes solid. Reverse light & brake light work just fine. Multifunction switch, light sockets, light assembly...


Sounds like the relay is burning out. When the lights stop flashing does the indicator on the dash light up and stay on and/or does the exterior lights light up and stay on? If the indicator light is staying on then you have a wiring problem to the lights or you have the wrong bulb/ bulbs. If the exterior lights stay on it is a bad relay or power to the relay.

Oct 31, 2010 | 1999 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...