Question about Cars & Trucks

Open Question

Need to reset for auto cycle and sanitize. timer stays on 2:10 and won't go to 2:30

Can't find my manual, so I need to reset the system

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drive cycle


The Internet has a large number of web sites
where you can buy service manuals and schematics
from bookstores, publishers, and other collectors.

Factory Auto manuals
http://www.factoryautomanuals.com/
search for : factory service auto repair manuals

Repair Service auto Manuals
where to buy Factory Service Auto Repair manuals
http://www.repairservicemanuals.com/
the largest collection of Automotive Repair Service
Manuals and Owners Guides on the internet. Our
database currently holds over 54,000 entries dating
back from 1940 to more recent 2011.

Chilton Repair and Service Manuals
http://www.chilton.cengage.com/

Haynes Repair and Service Manuals
http://www.haynes.com/

Feb 13, 2014 | 2004 Chrysler Sebring Sedan

1 Answer

92 park ave AC won't go to auto stays on economy


If the freon level is ok, you have an electrical problem somewhere. The system will not activate because the control module "thinks" the freon level is low or because of another problem. It could be the module too.
You'll need a shop manual to get the test procedures for climate control ac to check the components and circuits.

Jun 11, 2013 | Cars & Trucks

1 Answer

Abs light stays on and goes off occassionally. What is the best way to get to the source of the problem?


I don't understand these questions

Any dash light you get is a Vehicle System
Malfunction ( no owners manual)

They have been with us for 30 years now,
still hundreds of questions a night

Study OBD2 Systems on the internet

All check lights need immediate attention

Check for Codes
Diagnose
Repair

Do so in a few days of any light on dash,they
won't go away & won't pass inspection & eventually
will end in costly repairs

Jun 08, 2011 | Chevrolet Blazer Cars & Trucks

2 Answers

Oil maintenece light is on. Oil level is good. Could a clogged filter make this light go on?


This should only be indicating time for an oil change. Now, if the red, check engine light comes on, then you have an oil/engine problem.

Possibly the maintenance light wasn't reset when the last change was done. If you don't have the owners manual to check, I found a referenced method (below) to reset it through AMSOIL synthetic oil products. Good Luck

To reset Engine Oil light. Turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. You will need to reset the system again.

Feb 09, 2010 | Saturn L-Series Cars & Trucks

2 Answers

How do i get the engine light to turn off so i can smog it? The emiisions are perfect but the light stays on for some reason


some thing is not right--have vehicle sanned for trouble code most auto stores usually will scan for free such as auto zone / advanced auto check ur local area-fix or replace whatever is causing problem dont reset code after fix wait 24 hrs if no reset than have place that scanned --rescan and reset engine light u now have to wait for a few cycles and or at least 120 miles before emissions resets itself for testing same goes if u disconnect battery to clear codes emissions has to cycle back up

Jan 22, 2010 | Subaru Legacy Cars & Trucks

1 Answer

Engine light stays on after replacing gas cap on my 2003 Dodge tr


usually a few start ups or mileage will do or go to an auto store some scan vehicles for free such as auto zone / advanced auto check ur local area and have them scan and reset trouble code

Jan 20, 2010 | Dodge Pickup Cars & Trucks

1 Answer

My check engine light has came on and I went and had it checked at auto zone and they said it was a code 128 I added coolant but the light remained on after driving for over 30 minutes. what else could it...


drive more like 100 miles or so you have to reset the drive cycle to clear the code. if the light stays on take it to a mechanic. autozone messes peoples stuff up, i work for emission inspections in nevada.

Aug 03, 2009 | 2002 Kia Sportage

1 Answer

Replaced ctm unit and truck won`t stay running.


there are 2 sensor on the carb . you may need to replace both to find out whiche one it is . try this also give it gas while starting and when it starts you will have to keep your foot on the gas a little to keep it running if it runs that way its one of the 2 senors .

Jan 20, 2009 | 1997 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...