SOURCE: need cylinder head gasket torque specs.
looks like there is special sequence to reassemble and tightening, a quick note replace any bolts that have two punch marks.tighten as follows: x x x x x 10 4 2 6 8 x x x x x 7 5 1 3 9 torque all down to 15 ft lbs torque to 30 ft lbs plus 90 degrees. Good luck!
SOURCE: torque specs for cylinder head on a 200 ford focus
9 3 1 5 7
8 6 2 4 10 sequence for head
Spec for rod 38Nm
SOURCE: timing specs on 2002 grand am 2.2 liter dual over
rotate the engine till the crankshaft sprocket mark lines up with the second silver link on the chain, should @ the 5:00 position. on the right sprocket or the intake sprocket align the intake diamond with the copper link should set at the 2:00 position, and the triangle on the exhaust sprocket should line up with the other silver link in the chain approxamately at the 10:00 position. Once you get it in time, it is a good idea to put a bar on the crank and turn the engine over one complete revolution, just to make sure you got it timed right. hope this helps
SOURCE: I need to know the
Hello jenniebean12
The front axle nut torque is 174-235 ft. lbs. The rear axle nut torque is 130-174 ft. lbs.
I hope this helps.
Regards,
netvan
2,353 views
Usually answered in minutes!
×