Question about Ford Cars & Trucks

1 Answer

Where is the starter located on a 01 ford windstar? And is it a fairly simple to do yourself?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Ford Master
  • 762 Answers

It should be on the passenger side down low where transmission mates to the engine (bell housing).

Posted on May 21, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Shocks

Hi, as far as im aware these are roughly the same as the UK spec Nissan X- trail. The suspension system/shocks are relatively staright forward. Fairly basic system anyone with basic vechile knowledge should be able to change them.

Posted on Jun 11, 2008

  • 38 Answers

SOURCE: fue pump location 2001 ford windstar

Probaly in the fuel tank

Posted on Jul 19, 2009

  • 47 Answers

SOURCE: where is the solenoid located in 98 ford windstar,

the solenoid is attached to the starter and if somebody told you have to be replaced,is cheaper and quick to replace the starter

Posted on Sep 17, 2009

Testimonial: "thank you for your help!"

isaid
  • 302 Answers

SOURCE: where is the starter located on a 2003 ford

in front of the engine compartment access it from under the car, if u still cant find it just follow your positive battery lead it will go to starter

Posted on Oct 03, 2009

  • 75 Answers

SOURCE: need to locate the starter relay for my 2002 ford

SHOULD BE ON THE INNER FENDER NEAR THE BATTERY...

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 96 Ford windstar I just bought a new computer and it still won't start up it cranks but wont catch is there something else that can be the problem


Ford Windstar Starting/Stalling Problems - Edmunds.com

forums.edmunds.com > Ford > Ford Windstar

Oct 16, 2007 - 31 posts - ‎26 authors
Learn more about Ford Windstar at the Edmunds.com Car Forums! ... Occasionally, when it won't start, I have to press the fuel pump button .... the battery looked prettynew. so we purchased a new battery and it ran nice and .... the van still wont start. ijust paid 578.00 for the computer chip from the dealer, ... Ford Windstar Electrical Problems
31 posts
Apr 14, 2006
Ford Windstar Transmission
31 posts
Mar 20, 2006
More results from forums.edmunds.com

windstar won't start - sometimes - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Ford > Windstar
The up side is that you will have a spare door key for your windstar.....just won't startthe engine. The other thing that could impact the starter and the fuel pump ...

01 Windstar, won't start, anti-theft problem? - YouTube

? 0:39
https://www.youtube.com/watch?v=c_c0ULssC7M
Aug 15, 2009 - Uploaded by audra clark
2001 Ford Windstar won't start, the theft light flashes rapidly in the off ... NGS will power up but will not ...

Jan 26, 2016 | Ford Cars & Trucks

1 Answer

Where is the E G R differtail ciciruit located @ on ford windstar 01 engine size 3.8


the DPFE sensor located next to the egr valve follow egr valve vacuum hose it will lead you to the DPFE sensor.

Apr 25, 2013 | 2001 Ford Windstar

1 Answer

I am tying to locate my starter on a ford windstar wagon


Section 03-06: Starting System 1998 Windstar Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/22/1999 Starter Motor Removal
ani_caut.gif WARNING: WHEN SERVICING STARTER MOTOR (11002) OR PERFORMING ANY MAINTENANCE IN THE AREA OF THE STARTER MOTOR , NOTE THE HEAVY GAUGE INPUT LEAD CONNECTED TO THE STARTER SOLENOID (11390) IS HOT AT ALL TIMES. MAKE SURE THE PROTECTIVE CAP IS INSTALLED OVER THE TERMINAL AND IS REPLACED AFTER SERVICE.
  1. Disconnect battery ground cable (14301). Refer to Section 14-01.
  1. Raise the vehicle on a hoist.
  1. Remove the starter solenoid safety cap.
  1. ani_caut.gif CAUTION: When disconnecting hardshell connector at S terminal, grasp the plastic shell and pull off. Do not pull on wire. Be careful to pull straight off to prevent damage to the connector and S terminal. If any part of the connection is damaged, replace the damaged components.
    Disconnect starter cable and push-on connector from starter solenoid.
  1. Remove upper bolt.
  1. Remove lower bolt and starter motor.
Installation
  1. Position starter motor to engine and install upper and lower bolts finger-tight.
  1. Tighten the upper mounting bolt to 20-27 Nm (15-20 lb-ft).
  1. Tighten the lower mounting bolt to 20-27 Nm (15-20 lb-ft).
  1. Connect starter solenoid connector. Be careful to push straight on and make sure connector locks in position with a notable click or detent.
  1. Install starter cable nut to starter solenoid B-terminal. Tighten to 9-14 Nm (80-123 lb-in).
  1. Replace the starter solenoid safety cap.
  1. Lower vehicle to floor.
  1. Connect battery ground cable.
2010&c18=modelyear&c35=wsm%2cstarter%20motor%2csww%2c03-06%2cremoval%20and%20installation&s=1600x900&c=32&j=1.3&v=y&k=y&bw=1171&bh=491&ct=lan&hp=n&[aqe]

Apr 05, 2010 | 1998 Ford Windstar

1 Answer

I have a 1999 ford windstar but it wount start the engine will not turn


is it getting spark , if not then check the fuel system then the starter .it might even be something as simple as your starter relay.

Mar 18, 2010 | 1999 Ford Windstar

1 Answer

How to replace starter windstar 2003 V6 engine?


2003 Ford Truck Windstar 3.8L SFI 6cyl Repair Guide

Ford Windstar 1999-2003 - Starter Removal & Installation

  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle safely.
    NOTE When removing the hard shell connector at terminal -S-, grasp the plastic shell. Do not pull on the wire.
  3. Disconnect the starter electrical harness.
  4. Remove the upper starter bolt.
  5. Support the starter and remove the lower bolt.
  6. Remove the starter from the vehicle.

    e1d1735.jpg

  7. Fig. The starter is located at the lower front of the engine, and is visible through the air duct

To install:
  1. Position the starter in the vehicle.
  2. Install the upper and lower bolts. Tighten to 15-20 ft. lbs. (20-27 Nm).
  3. Connect the starter electrical harness. Tighten the starter cable nut to 80-124 inch lbs. (9-14 Nm).
    NOTE When installing the hard shell connector, be careful to push it straight on and make sure it locks in position with a notable click or detent.
  4. Lower the vehicle.
  5. Connect the negative battery cable.

I really hope helps with this (remember rated this help) Good luck.

Dec 31, 2009 | 2003 Ford Windstar

2 Answers

The car will not start .


try the solenoid first.

Starter Motor —3.0L (4V) Removal
syh~us~en~file=ani_caut.gif~gen~ref.gif WARNING: When repairing the starter motor (11002) or working underhood in the vicinity of the starter motor, note the heavy gauge input lead connected to the starter solenoid (11390) is hot at all times. Make sure the protective cap is installed over the terminal and is reinstalled after repairing.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Remove the bolts, pin-type retainers and the front splash shield.
  1. Remove the starter solenoid terminal cover.
  1. Remove the nuts and position the starter solenoid cables aside.
  1. Remove the nut and position the starter motor ground strap aside.
  1. Remove the upper starter motor nut and stud.
  1. Remove the bolt and the starter motor.
--------------------------------------------------------------------------------------------------
80dbb8c.gif

Oct 03, 2009 | 2000 Ford Taurus

1 Answer

Where is the starter located on a 2003 ford windstar located?


in front of the engine compartment access it from under the car, if u still cant find it just follow your positive battery lead it will go to starter

Oct 03, 2009 | 2003 Ford Windstar

2 Answers

Where is the solenoid located in 98 ford windstar, mounted under hood or on the starter itself?


Hello! The starter solenoid is located on the top of the starter on this vehicle. Hope this information helps!

Sep 16, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...