Question about Mercury Cars & Trucks

Open Question

Will 2001-2002 headlight assemblies work on a 2000 mercury cougar?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: Mercury Villager headlight assembly diagaram for removal

This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.

Posted on Dec 12, 2008

Ad
chuck943
  • 783 Answers

SOURCE: 2000 mercury cougar wont start

what is anti-theft light doing? It should come on solid for about 2 sec after you turn the key on then turn off. If it is flashing after this then it is not seeing the computer chip in the key and you have a PATS problem.

Posted on Jan 30, 2009

  • 1 Answer

SOURCE: 2000 Mercury cougar V6 Headlights and instrument light don't work

Naso228:

balkjr Check the 7.5 amp fuse thats under the dash labeled high beams and low beams. I like a idiot checked all the other fuses under the hood but neglected to check that one and it was blown. Once i replaced the fuse my headlights work fine but still no instrument lights. For whatever reason i was able to blow the fuse again by shorting out the dimmer switch so i checked it with a multimeter and it had voltage going in but none out. I unplugged the dimmer switch and looked into it and alias noticed a solder in the middle pin that had snapped off. Its proved trickier than i had expected to solder it back but i know for sure that it is the culprit because i was able to use a pin to reach in it and hold the solder point down to get connection and my instrument lights worked fine. You can look right into the switch and see the solder point thats broke if that seems to be the problem for you also it comes from the middle pin on the switch and solders straight to the board. Just look inside the switch is made fairly open.

Posted on Feb 08, 2009

crayzeetrayn
  • 837 Answers

SOURCE: REPLACE HEADLIGHT ASSEMBLY IN 2000 LINCOLN TOWNCAR

Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: 2000 Mercury Cougar Power door locks do not work on either door

Power door locks are on the same fuse as the alarm system. The fuse is located in the passenger compartment fuse panel under the steering wheel. There is a pull down lever that will release the fuse box. The fuse for the alarm system/locking system is #25. Yellow color and a 20 ampere rating.

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are common mercury cougar electrical problems?


check the fuse to the light module and check the module for operation.

Apr 25, 2014 | 2000 Mercury Cougar

1 Answer

Install replacement headlights ?


You need to get a pair of pliers (called "snapring pliers")to remove the retainers (the little silver "do-dads" holding the headlight assembly in place... on the back of the grille opening panel). There's 2 of them on each assembly. You get those off and the headlight assembly practically FALLS out

Sep 07, 2012 | 1990 Mercury Cougar

1 Answer

I need to replace the entire headlamp assembly units on both the driver and passenger sides of a Mercury Cougar V6 2.5l. The car was built in 2000 and badged as a "FORD COUGAR" where it was...


It will cost a fortune to buy brand new. You can find lot of second hand ones on ebay.co.uk and ebay.com. Lot of ebay sellers in UK wont ship overseas. If you are in USA then you can find on US ebay and there are heaps available. Use a headlight restoration kit and the light will become brand new again. If you need further info, let me know.

Jan 05, 2011 | 2002 Mercury Cougar

1 Answer

Can the factory headlight lens covers on a 2001 Mercury Cougar be removed and cleaned ? I can remove the entire healight assembly and change the bulbs, but the inside of the healight cover is dirty and...


The lincoln LS had the same problems, and the lens was held to the headlight assembly with a sticky glue.
To remove them, some guys were successful by warming the headlight assembly in the oven untill the glue softened up enough to be pulled apart.
Be careful if you try this, to much head and..oops I melted my headlight

Oct 13, 2010 | 2002 Mercury Cougar

1 Answer

Headlight lens removal on 2002 Mercury Cougar


Several car wax companys make kits to clean the outside of the headlight lenses. Check your local parts stores. It's usally pretty hard to remove the len, they are often glued on.

Mar 07, 2010 | 2002 Mercury Cougar

1 Answer

99 mercury couger-all headlights not working


check the fuses and relay that control the headlights

Jul 13, 2009 | 2000 Mercury Cougar

1 Answer

I need to install the Headlights on a '90 cougar. What tools will i need and what proceedures to take?


Do you just need to replace burned out bulbs or the entire headlight assembly? I replaced the assembly on my '90 Mercury Cougar when the lens cover came off (evidently while driving...it was just gone one day). Turns out you couldn't replace just the lens, had to replace entire assembly. I found one in a pick and pull junkyard and it was quite inexpensive. The assembly was held in place with three or four spring clips which can be removed with a pair of fine-nose pliers, but be careful, due to the age of the car, the spring metal in the clips is somewhat brittle, I had one of them break.

Apr 27, 2009 | 1990 Mercury Cougar

1 Answer

Headlight


Have you tried local auto recyclers ? Lots of them have a hotline service where they can tap into other yards for same part, to helpfind you one.

Jan 21, 2009 | 2000 Mercury Cougar

1 Answer

Hi, I have a 99 mercury cougar and I need to change the headlights. I am having difficulty finding the electrical connector so that I can pull the headlight assembly out and change the lights. Where is...


Headlamp Bulb Removal
  1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly .

Headlamp Assembly Removal
  1. Remove the radiator grille.7feecfa.gif

Remove the headlamp assembly.
2b42ecf.gif
remove the cover/
  1. f76b11b.gif
3.
sxu~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Do not touch the glass of the bulb with your fingers.
Remove the headlamp bulb (low beam bulb shown). 79891b8.gif

Jan 10, 2009 | 1999 Mercury Cougar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...