Question about 2002 Chrysler Sebring

Open Question

Wiring diagram for tcm on 2002 Chrysler seabring with

Posted by on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 67 Answers

SOURCE: What type of coolant, 2002 chrysler seabring

orange 5 years protection recommended chrysler which it has very solution

Posted on Nov 18, 2009

  • 5 Answers

SOURCE: chrysler town and country wiring diagram

Where is the amplifier located on a 2002 Town & Country? My stereo seems to be working, but there is no sound coming out of the speakers.

Posted on Dec 18, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 chrysler sebering wont shift out of low gear

Your car is in limp in mode to prevent further damage to transmission. P0605 Internal TCM error.
TCM= transmission control module.

Aug 24, 2017 | Chrysler Cars & Trucks

1 Answer

P700 code po750

code p0700 refers to transmission control system/ MIL- malfunction===causes--wiring ---TCM replace the TCM
code p0750 refers to shift solenoid9SS) A-circuit malfunction===causes --wiring---shift solenoid ECM/TCM. When the TCM is replaced then it should be fixed as the TCM is common in both faults.

Oct 13, 2013 | 1999 Chrysler 300M

1 Answer

2002 chrysler seabring what is the estimated cost of replacing the water pump

That would depend on the engine size and where you live. The water pump is around $50-$75 but if it is driven by the timing belt the belt is usually replaced too. Local labor rates vary from state to state.

Jul 30, 2013 | 2002 Chrysler Sebring

1 Answer

Chrysler sebring code

MAP (Manifold Absolute Pressure) Sensor or MAF (Mass Air Flow) Sensor or TPS (Throttle Position) Sensor. Not that hard you just need to know where to look so I will give you a link to look up codes :-)

Jun 28, 2012 | 2002 Chrysler Sebring

1 Answer

Horn honks 3 or 4 times when starting the car. it is a 2009 chrysler seabring

Check for loose wiring or exposed conductor particularly inside the steering column where the horn and the ignition wiring may have come in contact.

Sep 15, 2011 | 2009 Chrysler Sebring

1 Answer

What type of coolant, 2002 chrysler seabring

orange 5 years protection recommended chrysler which it has very solution

Nov 18, 2009 | 2002 Chrysler Sebring

1 Answer

I have a 96 chrysler seabring the break lights

check the brake light switch under the dash toward the top of the pedal make sure the switch,connector and wiring are ok check the fuse also

Jul 16, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

Hi, Got a Chrysler Voyager 3.3 on a 2002. Car in limp mode and speedo not operating. Fault code (P1698 no canbus message) Changed two speed sensors on side of transmission, all fuses ok and re...

How is your transmission shifting?
the reason I ask is because your code is a communication loss code between the TCM and the other module(s). It's not uncommon for the wiring problems to develop in the harness that runs from the PCM in front of the battery to the TCM on the Pass side inner fender. Look around where the harness is tie strapped to the transmission pan. it's common for the wires to break or be full of water especially after somebody has had the pan off or the transmission has been removed for repair. Can also be a wiring problem right at the PCM or TCM connector or the TCM itself TCM is transmission control module)
although not as likely as a wiring issue.
when communication is lost the transmission will go into limp mode which is 2nd gear and stay there. Sometimes it will come back every time the van is shut off. Not an easy fix but on the plus side not an overly expensive one if you're gonna tackle it yourself. You'll need a scanner that will give you input and output speed sensor readings and a wiring diagram. TCM's should be reasonably cheap used or even new, not sure haven't priced one in forever and the wrecking yard are full of them and even the connector(s) should they be required

Aug 04, 2008 | Chrysler Voyager Cars & Trucks

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides