Question about Cars & Trucks

Open Question

How do you replace the front fog light - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Saxo rear fog light working and front fog lights not working


try changing the relay for the front fogs,the front and rear are not connected in any way,check the fuse box lid for relay location ok

Jan 29, 2012 | Citroen Saxo Cars & Trucks

1 Answer

Signal lights dont work and want to know where the fog light switch is at


With the switch in sidelight or dip

position, pull the switch to its first

position to turn on the front fog lights.

Pushing the switch in or turning it to OFF
or AUTO will turn off the front fog lights (this is for the front)


With the switch in any position except

OFF or AUTO, pull the switch to its

second position to turn on the rear fog

lights. This will also turn on the front fog

lights unless main beam is selected.

Pushing the switch in or turning it to OFF
or AUTO will turn off the rear fog lights (this is for the rear)

Exterior lighting

Exterior lighting switch

A. OFF.

B. Side (parking) lights.

C. Headlights.

D. Auto.

E. Front fog lights.
F. Rear fog lights.

It is the round knob nest to the steering colume

Aug 18, 2011 | 2003 Jaguar X-Type

1 Answer

How do I change my fog light bulb in my 1999 oldsmobile alero


YOU HAVE TO REMOVE FRONT SPLASH SHIELD TO REPLACE FOG LIGHTS.THEN YOU REMOVE THE TWO BOLTS RETAINING THE FOG LAMP TO THE BACK OF THE FRONT BUMPER REINFORCEMENT BEAM AND LOWER THE FOG LAMP.

Apr 30, 2010 | 1999 Oldsmobile Alero

2 Answers

Front fog light out how do I replace it


underneath the offending fog light there is an access panel. its held closed with two 10mm bolts. take out the two bolts and reach inside for the fog light. there is a tab you must press inward to turn the the socket. turn the fog light socket and remove it from the fog light housing. replace the bulb, and reverse the steps for reassembly.

Apr 16, 2010 | 2000 Chevrolet Camaro

2 Answers

Fog lights are burnt out i would like to replace them ??


Front Fog Light Assembly

REMOVAL

  1. Disconnect the ground cable from battery.

  • Remove the two clips and lower mudguard.
  • Disconnect the harness connector.
Remove the lower bolts.

  1. Remove the mounting bolts and clip, and then detach the fog light assembly.
INSTALLATION

Install in the reverse order of removal.
Front Fog Light Bulb

REMOVAL

  1. Remove the front fog light assembly.
Remove the back cover.

  1. Remove the spring retainer, and then detach the fog light bulb.
INSTALLATION

Install in the reverse order of removal.

Oct 03, 2009 | Subaru Forester Cars & Trucks

1 Answer

How do you replace the fog light bulbs on a 2004 buick regal?


Notes FOG LAMP BULB REPLACEMENT - FRONT

REMOVAL PROCEDURE
f98bf40.gif
  1. Remove the front bumper fascia deflector.
  2. Disconnect the electrical connector from the front fog lamp bulb/socket. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
01c84b0.gif
  1. Rotate the front fog lamp bulb/socket counterclockwise to release.
  2. Remove the fog lamp bulb/socket from the front fog lamp assembly.
4065803.gif


  1. Install the fog lamp bulb/socket to the fog lamp rotating clockwise until fully seated. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
b182709.gif
  1. Connect the electrical connector to the front fog lamp bulb/socket.
  2. Install the front bumper fascia deflector.

Jun 16, 2009 | Buick Regal Cars & Trucks

2 Answers

How to replace fog light bulbs


hi..You will have to access the fog light bulb from below the vehicle.
Remove the plastic clips from the wheel well cover extension that is
below the fog light.once the clips are out and the plastic cover is pull
down,you should be able to see the back of the fog light.you can try
to replace the fog light bulb by removing the two 10mm bolts and slide
the fog light assemble out through the front of the bumper.Turn the cover
of the rear of the fog light and replace light.
try this out..
thank u..
kindly rate my response..

Jun 14, 2009 | 2004 Toyota Celica

1 Answer

How to replace a fog lamp with replacement bulb only on 2002 toyota 4runner sport edition???? the three screws on the bottom?


Well, these are the steps and I will post the pic here in a second...looks like 2 screws...but like I said, you can see the picture for direction on this.


Remove or disconnect the following:

Front turn signal lamp
  • Connector
  • 2 screws
  • 2 claw fittings
  • Fog lamp assembly
  • Fog lamp bulb as shown
  • Fog light unit

  • To Install
    1. Install or connect the following:
      • Fog light unit
      • Fog lamp bulb as shown
      • Fog lamp assembly latch the 2 claw fittings and 2 screws
      • Connector
      • Front turn signal lamp
    Trying to post the pics now....

    May 14, 2009 | 2002 Toyota 4Runner

    1 Answer

    How do you replace the fog lamp on a 1997 dodge neon? As best as I can tell, you have to take off the front bumper which I hope is not the case.


    To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light assembly, then you can remove the bulb and put a new one in.

    To replace the fog light on the driver side you will need to remove the front bumper cover so you can remove the vacuum box that is in the the way of the fog light bolt.

    To do so you need to remove the Torx (star) screws located in the front wheel wells as well as the bolts holding the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR."

    If any of the screws are rusted into place put some penetrating oil them to help loosen them up.

    PLEASE DON'T FORGET TO RATE!!!

    Mar 16, 2009 | 2002 Chrysler Voyager

    1 Answer

    Replacement of Fog light for BMW 1997


    Answer is on Bavarian Auto web site:
    3 Series 92 to 98 Fog Light Replacement-
    To install a fog light, insert a flat blade screwdriver through the front bumper grill and release the fog light retaining clip. Remove the fog light and disconnect the wiring harness. Installation is the reverse of removal.

    http://www.bavauto.com/shop.asp#e36fog

    Sep 01, 2008 | 1998 Toyota Corolla

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    16 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    yadayada
    yadayada

    Level 3 Expert

    75005 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...