Question about Saturn Cars & Trucks

Open Question

Saturn relay wont go into drive. It worked fine all day yesterday, went to go to work today pulles out of the driveway no problem, stopped at my mailbox and went to pull off and it wouldnt

I have a small evap leak code, could this be the problem?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

duyle 2009
  • 3 Answers


check the level transmission fluid and top up 1/2 litre in gearbox

Posted on May 14, 2009


SOURCE: Car died then restarted three times

Run a scan tool to determine problem, if nothing found take the car to the nearest acura service center to check for any recall onthe car.

Posted on Jul 09, 2009

  • 31 Answers

SOURCE: code 442 cleared it now code 455 whats up

there is a leak within the evap solenoid and lines.find the leak with a smoke tester.

Posted on Oct 04, 2009

  • 2309 Answers

SOURCE: 1998 saturn sc2 no power at fuel pump , relay fine

check for spark, fuel pump will not work if there is no spark

Posted on Oct 26, 2009

  • 8836 Answers

SOURCE: I have a 2002 jeep liberty and the check engine

check small line returning from gas tank to evap cannister for leaks, cracked hose. Also check gas cap for seal.

Posted on Sep 09, 2010

Testimonial: "very help ful info."

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

In gear but wont move

run the fault codes
indicates that the torque converter clutch servo/solenoid is not operational

Feb 16, 2018 | Cars & Trucks

1 Answer

I just drove my tahoe yesterday,pulled in the driveway and shut it off.went out to drive it today and it wont start.plenty of battery,gas.doesnt do anything when i turn the key at all,doesnt even try to...

it might be the solinoid on your starter motor, try tapping it with a hammer (its ok it is safe to do so) as the ignition is turned at the same time, it might free it...just an idea

Jan 31, 2010 | 1995 Chevrolet Tahoe

2 Answers

Fuel pump stops working,Then runs again later

You don't say how old the truck is - or how old the pump is - most likely it is the pump 'dying' as you try it -

I would look near the tank and find the ground wire -[ it may be on top of the tank] - the most common fix is the fuel pump and sadly it sounds like this is it --

Also - Take down the Vin # and call the local dealer - - ask about recalls and Service bulletins.

Dec 28, 2009 | Chevrolet S 10 Cars & Trucks

1 Answer

Afterjump off car want hold charge

Battery is probably bad, even Walmart can check the battery in a few seconds. Go from there.

Jun 12, 2009 | 1993 Saturn SL2

1 Answer

2003 Trailblazer wont start

check the Ignition Starter Switch (tipical on tb)

Oct 30, 2008 | 2005 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides