Question about Cars & Trucks

Open Question

PLS I ALSO NEED HELP ON HOW TO FIX WIRES THAT CUT OFF FRM THEIR POSITION ON HOT BLOWER. MODEL 8032A++ IN A DIAGRAM.

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Zim1308
  • 543 Answers

SOURCE: i am needing a wiring

Chilton manuals are the easiest way to go. They can be obtained through your local parts store (about $30 USD) and often at times come in handy for the typical DIYer.

Posted on Apr 28, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagram for heater blower wiring ford contour blower not working some wires look melted


I need model year to be sure I post the correct diagram? Probably a two wire connector at the blower motor, voltage and ground. Check voltage and ground, if your missing one or the other, track that circuit. If you have both good voltage and ground with no blower action, suspect the blower motor. I need more info.

Dec 17, 2016 | Ford Cars & Trucks

2 Answers

2009 blower motor not working.yellow wire has power when key is on even if fan speed switch in off position. Shouldn't it only have power when fan speed switch is turn to on?


It depends on how the circuit is set up , It may go through the fan to switch to ground . What make , model an year vehicle ?

Jul 15, 2016 | Cars & Trucks

1 Answer

Hot air through floor in 99 Suburban when blower is switched off


I the short answer is yes. The truck has a flow-thru vent feature as does most GM products. When the fan switch is off the outside air would flow into the truck.
I thought you could still direct the air by way of the control panel, but by the wiring diagram it looks like everything is disabled when the fan switch is in the off position.

Aug 24, 2012 | Chevrolet Cars & Trucks

1 Answer

I am needing a wiring diagram o a 1972 dodge charger s/e, 400, someone has cut and taped off some of the wires, on the motor, so some of the wires under the dash gets hot, my brother said he could fix the...


Chilton manuals are the easiest way to go. They can be obtained through your local parts store (about $30 USD) and often at times come in handy for the typical DIYer.

Apr 28, 2011 | Dodge Charger Cars & Trucks

2 Answers

My 1995 Lumina is overheating all the time can only drive it a few blocks before heat gauge goes to the right all the way and hot light comes on. Had thermostat replaced and it seemed to help..for a...


When the heat gauge shows hot and the hot light comes on the cooling fans must come on therefore there is a problem with the fans. The fuses been replaced so that is ok just check if it is not blown again indicating a short circuit in the fans. If that is OK check the wiring leading to the motor if it is not disconnected somewhere. Look on the engine where the fan heat sensor is by following the wires from the fan and check the connection. Change the fan heat sensor as last resort.

May 23, 2017 | 1995 Chevrolet Lumina

1 Answer

1995 heater blower motor: someone has replaced it before my sister bought it. The problem is it is wired incorrectly, the blower runs only on high continuously no mater where the fan speed switch is...


Since its presently working, don't mess with it yet. You can put a toggle switch in between so you can turn it on and off (you can even mount it under the dash). Get a good wiring diagram and use it to make sense of what you have.(Chilton makes a good diagram book which can sometimes be found in the library) I would not rely on Haynes for this,,, I've seen their diagrams and even with 30yrs in the business, I can't make heads or tails out of their stuff over 90% of the time!!)
Likely, there was a problem in the system to start with and the previous owner opted to just hot wire it rather than repair it. Therefore your problem is not only locating and re-connecting stuff, but figuring out what the other guy either didn't want to fix or couldn't figure out himself! Take your time with this and you can figure it out!!! Though this may not qualify as a "solution" it will help get you pointed in the right direction!
Good luck

Jan 02, 2009 | Ford Escort Cars & Trucks

2 Answers

Blower Motor on a '98 Olds Intrigue


THe blower motor is under the dash. You will have to take out the glovebox and half of the dash to get up in there, but if you have the time and the energy you can fix yourself. Will have to disconnect heater core hoses under the hood

Jan 01, 2009 | 1998 Oldsmobile Intrigue

1 Answer

Heater blower


you will need to get the blower motor change , it is drawing to much current and causing the wires to get hot

electech

Nov 25, 2008 | 1999 Kia Sportage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...