Question about Cars & Trucks

1 Answer

Can some one tell me how I can take out the backseat of a 94 grand prix I know there's bolts I'm just not sure where they are located

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 8,274 Answers

From autozone.com

  1. Remove the two bolts at the base of the seat bottom (one bolt for buckets).
  2. Remove the seat bottom by lifting up and pulling out.
  3. At the bottom of the seatback, remove the two or four anchor nuts.
  4. Grasp the bottom of the seatback and swing upward to disengage the OFF sets on the upper frame bar. Then lift the seat and remove.
To install:
  1. Slide the seatback into place and make sure the OFF sets are engaged to the seatback.
  2. Install the retaining nuts and tighten to 89 inch lbs. (10 Nm).
  3. Install the seat bottom into position and tighten the retaining bolts to 18-19 ft. lbs. (25-27 Nm).

Can some one tell me how I can take out the backse - 0900c15280068413-zgqdyflnyrgwy1c3pxhhgqmu-4-0.gif

Posted on May 18, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76164 Answers

SOURCE: i need to locate the map sensor on my 98 grand

Your engine doesn't use a MAP sensor (Manifold absolute pressure), it uses a MAF sensor (Mass Airflow), they both provide the same information about engine load but in a diff way. here is a picture of your sensor.
9a5375f.jpg

Posted on Mar 17, 2009

VWdan
  • 114 Answers

SOURCE: Where is the AC Low pressure valve on a 1999 Pontiac Grand Prix?

sometimes its behind the alternator real close to the firewall. Find the bigger of the two hoses and pipes the low side is always bigger. Also the cap is blue and the fitting for the charging can will only fit on the right valve.

Posted on Apr 24, 2009

  • 521 Answers

SOURCE: I have a 1997 Pontiac Grand Prix air temp sensor may be bad

the air sensor yur thinking of is usually found out front of the car on the post that supports the hood latch betwween the radiator assemblies and the oute decorative grill. go to your auto parts store like autozone and ask for the ambient air temp sensor. then if they can, ask for a diagram of its location. Its real easy to replace usually one bolt and one wire clip. Autozone has /offers these do it yourself repar guides that can help you .

Posted on Jul 22, 2009

  • 1596 Answers

SOURCE: 2002 grand prix motor 3.8 just want to know where

LOCATION is Oppisite END OF UPPER RADIATOR HOSE
Drivers side of engine BEHIND Top ENGINE Torque Mount
Thermostat Replacement

  • Tools Required
  • J 38185 Hose Clamp Pliers
Removal Procedure
  1. Remove the fuel injector sight shield.
  2. Partially drain the cooling system.
  3. Use the J 38185 in order to reposition the hose clamp from the water outlet housing.
  4. Remove the radiator inlet hose from the water outlet housing.
    1. Remove the water outlet housing bolt and stud. Remove the water outlet housing and gasket.
    2. Remove the thermostat.
    3. Inspect and clean the water outlet housing mating surfaces.
    Installation Procedure
    1. Install the thermostat.
    2. Install the gasket and the water outlet housing. Notice: Refer to Fastener Notice in Service Precautions.
    3. Install the water outlet housing bolt and stud to the water outlet housing.
      • Tighten the water outlet housing bolt and stud to 27 Nm (20 ft. lbs.) .
        1. Install the radiator inlet hose to the water outlet housing.
        2. Use the J 38185 in order to reposition and install the hose clamp to the water outlet housing.
        3. Fill the cooling system.
        4. Install the fuel injector sight shield.
        5. Inspect for leaks.

Posted on Oct 31, 2009

  • 1146 Answers

SOURCE: Location of mass air flow sensor, 2000 Grand Prix GTP

Hi:
The mass air flow sensor is a round sensor that is mounted in the air intake, between the air cleaner box and the engine throttle body.

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where are the fuze panels on a 94 pontiac grandprix


There is an interior fuse panel located on the passenger side of the dashboard. If you open the passenger door on the side of the dash you will see a cover that has a finger pull. Lift it off and you will find the fuse panel directly behind it.

Dec 04, 2014 | 1994 Pontiac Grand Prix

1 Answer

Cant figure out if my fuel pump is under my backseat or if i have to drop the gas tank to replace it on my 2004 pontiac grand prix


Normally gm you got to drop the gaz tank but some model its in the trunk remove the carpet in the trunk near the seat you should see and oval pease the put is under that might have to remove a few bolt to see the pu,p thank you and please rate the awnser

Jan 10, 2014 | 2004 Pontiac Grand Prix

1 Answer

Dimensions of starter mounting bolts for a 1992 pontiac grand prix se 3.1L


THE AUTO PARTS STORE AND DEALERSHIP WILL TELL YOU.ALL YOU NEED TO KNOW IS YOUR ENGINE SIZE.

Oct 20, 2010 | 1992 Pontiac Grand Prix

1 Answer

How to install rear struts on 94 pontiac grand prix


Struts are pretty easy to remove. 3 nuts in trunk under carpet then there are 2 bolts with nuts that hold the bottom to the rear axel. then 1 stabalizer bolt. Once the nuts are off the 2 bottom bolts you drive them out with a hammer. They are tapered so that hammer wont hurt them.

Jul 16, 2010 | 1994 Pontiac Grand Prix

2 Answers

Where is crankshaft sensor located on a 1989 pontiac grand prix with a 2.8l v6


Will be on the side of the engine block.Held on with one bolt that screw into the block, remove bolt and sensor slide out.

Jun 18, 2010 | 1989 Pontiac Grand Prix

1 Answer

I cant seem to find the bolt used to relieve some tension for my belt in my 2001 grand prix gt. could u please tell me where it is located?


This uses a self adjusting tensioner.This vehicle should have a series II 3.8L.The adjuster is located just under the alternator and slightly to the right.If trying to remove the belt a 15mm headed bolt runs through the tensioner pully turning it counter clockwise should loosen the belt tension.

May 19, 2010 | 2001 Pontiac Grand Prix

1 Answer

Pontiac 2001 tcc replacement


i have an 2002 grand prix gt with a bad tcc silinode sensor dont knoow where its located at...anyone that can tell me would be great

Mar 23, 2010 | 2001 Pontiac Grand Prix

1 Answer

92 grand prix 16" rims (factory)


no go to a junk yard and they will tell you what will fit

Oct 07, 2009 | 1992 Pontiac Grand Prix

1 Answer

I have a 1997 Pontiac Grand Prix air temp sensor may be bad


the air sensor yur thinking of is usually found out front of the car on the post that supports the hood latch betwween the radiator assemblies and the oute decorative grill. go to your auto parts store like autozone and ask for the ambient air temp sensor. then if they can, ask for a diagram of its location. Its real easy to replace usually one bolt and one wire clip. Autozone has /offers these do it yourself repar guides that can help you .

Jul 22, 2009 | 1997 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...