Question about GMC Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.
The ohter is under the dash and above the pedals, this one is much tougher to access.
Your Owner's Manual should tell you where the fuses are that you need to access.
Posted on Oct 20, 2008
it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you
Posted on Mar 16, 2009
2002 GMC Yukon Car Stereo Wiring Guide
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
Posted on May 24, 2009
the relay is built into the speed resistor or motor control module ) depends if you have automative or manual heater controls. is automatic it will be motor control module and manual is the resistor module. these units are located beside the heate fan motor. the motor helps keeps the unit cool. just unbolt the module, unplug it and install new one. Just check to make sure the connector is good.. The heat created by the connection sometimes melts the power or ground leads (red or black) and if this is so you will need to replace the pin.
Posted on Sep 01, 2009
you have to fix the problem with ur brakes- first check the wiring ,connectors and connection clips to the abs sensors and modulator if looks ok than have truck scanned some auto stores such as auto zone / advanced auto do it for free the code will give u a start point towards fixing ur problem--visual inspection of brakes doesnt always show problem
Posted on Nov 26, 2009
Tips for a great answer:
Jan 26, 2016 | GMC Cars & Trucks
Feb 27, 2015 | 2003 GMC Yukon Denali
May 03, 2014 | 2005 GMC Yukon Xl Denali
Mar 21, 2014 | 2003 GMC Yukon Denali
Oct 25, 2010 | 2005 GMC Yukon Denali
Feb 19, 2010 | 1999 GMC Yukon Denali
Jun 26, 2009 | 1999 GMC Jimmy
22 people viewed this question
Usually answered in minutes!