Question about Cars & Trucks

Open Question

Directed ready remote lets me start engine but i cant shut it off engine keeps running

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 ford f-150 truck has a coolstart remote , doors lock, and unlock with remote but engine does not start


It may be the Security module. The "cold start" routine is necessary to make the engine run cold. When you are already inside the vehicle and turning the ignition switch it is not using the "wireless" feature of the FOB's. The ignition switch is hard wired to the vehicle module and would be sending the signal through a wired connection. For the warm start, the "cold start" sequence is not needed and all this proves is you have spark and fuel. Many engines are running too lean to start without the "cold start" sequence. Another remote possibility is a stuck temperature sensor is keeping the cold start off, but that does not explain the truck starting with a key.

Jan 23, 2017 | Ford F-150 Cars & Trucks

2 Answers

Honda civic check engine light flashing


there is a code in the PCM that needs to be checked out. a light the stays on tells you this a flashing light tells you what ever the problem is can cause a running problem possible engine damage and is allowing the emissions to go out of range.

Sep 05, 2014 | 2003 Honda Civic

1 Answer

How to use toyota fielder car key less remote controller?


There are no special instructions to use the remote controller. The main requirement is to have the remote controller in your hand or in your pocket. When you reach within the range of 1 to 2 meters from your car the radio waves from your controller talk to the transponder ecu located within the car to match the programmed codes. If the codes match with each other it disarm the anti theft system, illuminate the room light, unlock the doors and is ready to start by depressing the brake pedal and touching the push start button.
Precautions:
1. Never place the remote controller under the direct sun light.
2. Keep the remote controller away from heat.
3. Keep the remote controller away from any kind of magnets.
3. Take care not to let the remote controller fall from any height.

Nov 26, 2013 | Toyota Corolla Cars & Trucks

2 Answers

Astrostart won't start the car


You may need to reset the system.

SEQUENCE ACTIVATED BY THE PARKING BRAKE .
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply the parking brake Once Twice
Note: The system can be set - at time of installation - to require that the parking brake be applied once or twice.
If set for two actuations, pause one second between the two.
4. Remove key from ignition (the system keeps the engine running).
5. Exit the vehicle.
6. Within 60 seconds, close all doors.
7. The system will stop the engine and blink the parking brakes once to confirm the sequence is valid (vehicle is
ready for a remote start command).
SEQUENCE ACTIVATED BY THE REMOTE CONTROL
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply parking brake.
4. Send the start command (Model 801 & 2101 - Model 903 ).
5. Remove key from ignition (the system keeps the engine running).
6. Exit the vehicle.
7. Using the remote, send the STOP command. The system will stop the engine and parking lights will blink once
to confirm that the sequence is valid (vehicle is ready for a remote start command).
http://www.astrostart.com/Support/Guides.aspx

Nov 27, 2012 | Cars & Trucks

1 Answer

1999 Mazda I changed the battery and spark plugs everytime i driver it for a good min it shuts off and wont start unless I let it sit for about 30 mins will not stay krunk need some advice


This could be several possible causes. If possible I would find out what the spark plugs looked like when they were pulled from the engine. Since you had the radiator changed assuming that diagnosis was correct for the overheating you may or may not have more severe internal problems with the engine. Start with what the spark plugs looked like and possibly what the present spark plugs look like.

Sep 13, 2012 | Mazda Cars & Trucks

1 Answer

Hi---I have a '94 honda accord that is having a problem staying started. It will start---but as soon as I let go of the key it shuts off----don't know if it might be the ignition or something in the...


I have had this problem on two separate honda accords. Can you keep the engine running if you turn the key to start and then let the key come back just a little? I have had two faulty switches. I could keep the engine running but I had to hold the key between run and start position.

Jun 15, 2010 | 1992 Honda Accord

2 Answers

99 dodge durango keeps shuttin down every so often cleaned battery cables and replaced clamps on both terminals worked for a day then same thing and security light will come on if i unhook pos cable and...


2002 Durango shuts down without warning. Sit for about 30-45 min and will restart, run for a while, and shut down again. Shows "NO BUS" code. Took it to Dodge Dealer and had a diagnostic done....nothing!!! Have changed PCM, crank shaft sensor and am getting ready to RUN IT OFF A CLIFF if I can get it running long enough!!! It is a black hole and we are getting no where!! I can't even sell the dang thing!!

Aug 14, 2009 | 1999 Dodge Durango

1 Answer

Starter keeping trying to turn over the engine and won't shut off


Pulling the battery is fine, I would suggest the remote starter or the ignition switch are bad. Its not the solenoid if it starts the car, solenoids default to off not to on.

Jul 16, 2009 | 1996 Toyota 4Runner

1 Answer

1995 Ford Thuderbird


Depending on which type of carburetta this car has, it may be that the rubber diaphram has a tiny pinprick of a hole in it. This will affect the vacumn and the fuel control. An easy way to test this is to allow the car to rest without the engine running for a few minutes, start the engine an increase the power whilst at a standstill and see how long it takes before the engine shuts down, then let it rest again for a few minutes, start the engine and let it run just on tick over, if it carries on running for a much longer period than before then you may have the answer.
Hope this helps Bomber667

Dec 01, 2008 | 2006 Ford Thunderbird

2 Answers

Alarm wont let me start the car


you need the remote control of the alarm to turn the alarm off.

you may need to change the battery of the remote in case it would no longer control the alarm or if you have a valet switch to turn off the alarm, then use it.

the immobilizer is working that is why you can not start the car.

tnx 4 using fixya,

drcool

Sep 13, 2008 | 1994 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...