Question about Cars & Trucks

Open Question

Where is the speed sensor Places in my Laguna ii, 1.8 from 2002

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im looking for a tyre pressure sensor for my renault laguna 2033 plate but not sure what im looking for or how to fit one thank you


1. The tyre has to be removed to fit the tyre valve/ sensor unit to the wheel. . Tyre dealers will do this for you when you supply the sensor.

2. Any renault dealer parts department can sell you a new sensor.

3. The new sensor has to be programmed to the car's tyre pressure monitoring system (TPMS).

3. Here is a list of information about the Renault Laguna tyre pressure sensors to assist you. The 2nd link below shows a picture of the tyre valve/sensor unit that fits to your wheel.

http://www.petercoopercarrepairs.co.uk/renault_laguna_mkii.htm

Renault Laguna Megane Tyre Pressure Sensor World Car Parts Store

Jan 07, 2016 | Renault Cars & Trucks

1 Answer

Whats ford windstar error codes p0715 mean


I hope this helps and is what your looking for... good luck

http://www.fordobdcode.com/p0715-ford

Ford P0715 OBD-II Trouble Code Definition:
P0715 Input Shaft Speed Sensor Circuit Malfunction
P0715 Ford OBD-II Trouble CodeDescription:
OBD Trouble Code P0715 Input/Turbine Speed Sensor "A" Circuit What does the code mean? OBD-ii Code P0715 definition:
The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission Control Module (TCM) and Engine Control Module (ECM). Symptoms Sumptoms of OBD code P0715
- Engine Light ON (or Service Engine Soon Warning Light) - Possible shifting problems Causes Causes of the OBD-II code P0715
- Transmission speed sensor circuit is open or shorted. - Poor transmission speed sensor circuit connection - Faulty transmission speed sensor The Error code is generally activated on detection of the following conditions: Diagnostic Trouble Code (DTC) P0715 is detected when TCM or ECM does not receive the proper signal from the sensor. Solutions

Jun 22, 2014 | 1999 Ford Windstar

1 Answer

Why is my renault laguna ii losing power and will not rev above 4000 ?


had similar issue but with laguna 2.0 IDE where there are 2 sensors at the end of the fuel rail left hand side of engine looking into engine bay from front of car, they both look like cylinders about 2 inches high with terminal points for wires on top, replacing the sensors resolved the issue but they were really expensive and only available from renault, i was able to run the car as long as i stayed below 4000 revs if i removed the lead from the top of one of the sensors. be aware if you do change the sensors yourself, do it a while after you have last used the car and engine is cool, as removal of sensor causes the pressurized fuel to come out at speed all over you. hope it helps

May 30, 2014 | 2005 Renault Laguna 1.8

1 Answer

Renault laguna indicator


Bring in to dealer, possible abs sensor failure.

Apr 13, 2014 | 2005 Renault Laguna 1.8

1 Answer

Laguna ii auto transmission fluid


The gearbox on these models in non serviceable. There is however a dipstick to check the fluid. You may be able to add through the dipstick tube. That's how we did it on old Hondas.

Jun 18, 2013 | Cars & Trucks

2 Answers

I am having problem with my renault laguna II driver door sensor, it will not recognize open door, i don´t know were the sensor is to check it, it appears isn´t a microswitch, may someone confirm...


It is a micro switch and it's in the door latch on the door. If you use the side of a screwdriver blade to push the bit in the latch right up on one of the doors that have working switches ie door light coming on, door open coming up on the dash you will see that the light etc goes out. It's the same for the the laguna 1 and the Laguna 2. All I did to correct the problem on my Laguna 2 was spray loads of WD40 in the latch and it started to work but only for a couple of months so I am getting a latch from the breakers. I can only hope it has a good switch in it.

Nov 17, 2009 | 2003 Renault Sportwagon

1 Answer

Coding a key for a renault laguna


Renault Laguna II Key Remote Control Programming
LAGUNA II INFRA RED RESYNCHRONISING
1. Turn the Ignition OFF.
2. Press the central door locking button for more than 5 seconds. Note: the door should lock then unlock.
3. When this happens 15 seconds is allowed and the immobiliser warning light illuminates.
4. Point the 1st key at the receiver and press the button once, the doors should lock and unlock.
5. Point the 2nd key at the receiver and press the button once, the doors should lock and unlock.
6. Check the remote control unlocks and locks the doors.

Mar 24, 2009 | 2004 Renault 181

1 Answer

Laguna II seat adjustment


The seat controls should be two switch in the shape of the seat plus one memory button.
Get the seat where you want it then push and hold the memory button until you hear a beep.

Jul 15, 2008 | 2004 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...