Question about 1998 GMC Safari

1 Answer

Break light switch for 1998 safari

We're do I find the switch

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • GMC Master
  • 45,144 Answers

Above the brake pedal arm

Posted on May 17, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 Safari Sahara brake light lights don't come on. All other lights work. What might be wrong?

Brake light switch , fuse . What vehicle is it ? 1998 GMC Safari ? Check the STOP/HAZ fuse #1 20amp located in the insturment panel fuse box .

May 17, 2017 | Cars & Trucks

2 Answers

Interior lights wont turn off 1998 gmc safari van

Did you try the door switches? Pull the fuse, Unscrew and disconnect he wiring- DON'T let it pull back into the door. Tape it down, but don't let the wire touch anything. Replace the fuse. Is the light off? YES. Replace the switch. NO? Repeat the above steps for each door switch. Find the culprit and replace it. If the lights continue to stay on, then go to the dash panel and replace the panel switch where the panel dimmer wheel is at. I think the entire headlight switch may have to be replaced if there is no wheel on the dash. Hope that helps.

Nov 05, 2014 | 1998 GMC Safari

1 Answer

1998 GMC Safari van won't start.

Check your switch that runs to your aternator.make sure is grounded .if not get a sand paper and sand it down.also check the switch that plugs in to the alternator.

Dec 08, 2017 | 1998 GMC Safari

1 Answer

1998 Ford Expedition rear break lights not working

check fuses. if all good there i would use a test light to check power to brake light switch on pedal. should be two wires. one will be hot all the time and the other will be hot when brakes are applied. if you have power there and no lights still i would suspect multifunction switch is bad on steering column.

Sep 14, 2012 | 1998 Ford Expedition

1 Answer

I have no brake lights but all the others work. checked fuses and connections and bulbs

Check up under the dash on the brake peddle arm for the brake light switch.Check to see if it is loose or if the switch is bad.

Sep 24, 2011 | 1998 GMC Safari

1 Answer

1998 Accord: 1998 honda accord sedan break lights stay on...

In all probability, the brake switch got stuck in the closed position. One way to test it is by trying to move the shift lever from Park to Neutral without depressing the brake. If you can do this, then the switch is damaged. It is very simple and inexpensive to replace.It is located a few inches above the brake pedal rubber pad.

May 17, 2010 | 1998 Honda Accord

1 Answer

Anti lock break light on

Have the sensor checked first. If that's not the case, the system may be defective. Only be having it checked by a trusted mechanic will give you peace of mind. Get an estimate first! Good Luck

Sep 10, 2009 | 1998 GMC Safari

2 Answers

Break light problem

If you have a test light, check the brake light switch (usually mounted at the top of the break pedal arm). The switch will have voltage on one wire....when the pedal is pressed, the switch closes the circuit and sends voltage to the other wire connected to the brake lights.

Jun 30, 2009 | 1998 Acura TL

1 Answer

1998 safari van - removal of passenger internal door panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. then you just remove the bolts to the mirror

Mar 22, 2009 | 1998 GMC Safari

1 Answer

1998 Gm Safari

i think it is the neutral safety switch down on the trans shifter linkage.

Sep 17, 2008 | 1998 GMC Safari

Not finding what you are looking for?
1998 GMC Safari Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides