SOURCE: How to Remove the Rear Bumper - BA Fairmont/Falcon
Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.
SOURCE: my 2003 ba ute transmittion has problems, when in
check the codes but is likely the shift position sensor on trans
SOURCE: have 2005 BA MK11 shockwave blue falcon,paint
You may want to reference the Ford Australian Forum Boards.
There has been active discussion on owners being compensated
for particular model years due to a fault with the Shockwave paint.
On a separate note, the auto industry uses our technology for paint durability measurements (film thickness).
We have issued two press releases and have contacted Ford Senior Management on the impact of outsourcing paint applications process and quality control to the Paint Suppliers.
Press Release 1
New Books Reveal Vehicle Paint Quality Flaws Associated with Outsourcing
Press Release 2
Billions Discovered for Recovery by Automakers
We have released two books -
Basic Guide - For the Consumer
Technical Guide - For The Automaker and Auto Dealer
"MAKING IT RIGHT'
Why your Car Payments
are lasting longer than your
FACTORY PAINT JOB
We do have research data on various automakers vehicle models from the factory which shows they were released to the automaker, auto dealer and consumer below Ford's paint thickness specifications.
Low film thickness results in paint peeling, stone chipping and body rusting.
Paint applied too thick will crack.
We are advocating a "Truth in Finish Disclosure" to protect automakers, auto dealers and consumers.
You may want to advise your auto dealer on the book and do a search inside the book on either Amazon or our website for additional information.
SOURCE: ba falcon heater
Just had the same thing happen to my BA. No hot air. I'm a bit of a handyman so I had a go myself. 8 Hours is a reasonable estimate. You have to remove the steering column and entire dashboard to get the bugger out. Not a job I would attempt again.
SOURCE: My 2004 BA Falcon won't start. Apparently it's low
ba engine generally is strong, common fault is ecu, if hard starting when cold, pour hot water on computer and it should start, also have you scanned vehicle?
28 views
Usually answered in minutes!
×