Question about Cars & Trucks

Open Question

God bless , How do you check your application and if I want to change some things on it.how can I do so .My Id no is **********083. Thank you

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: lexus ls 400 air suspension stop working

If this light is flashing, there is a problem somewhere in your air suspension system. You can check to make sure its powered on in the trunk on the driver side. Behind the carpeting. This is a common issue with that particular year and model. The system tends to go bad righ around the 15 year old mark or so. Also if the light is flashing, the system is not working. Your just riding on the regular suspension.


Hope it helps

Posted on Feb 19, 2009

Ad
saabreur
  • 51 Answers

SOURCE: I need help with my water pump in my saab900-sport.

The water pump is located at the firewall end of the engine. If your car has A/C. it makes it a little more difficult, as you'll find the compressor is in the way and difficult to work around. ONLY if your A/C system is empty, could you disconnect the hose to the A/C compressor. Otherwise you might consider disconnecting the entire compressor from the engine (but not opening theA/C sytem so you don;t loose the gas) and moving it out of the way if you can't work around it.

There are four bolts holding the pulley to the case; loosen these then remove the drive belt(s). The belts hold the pulley steady while you loosen the bolts.

Remove the pulley completely.

Then remove the bolts holding the pump to the case; NOTE the position of the longer bolts - you'll need to reinstall these in the same locations!

Install the new pump in reverse order; make sure you use new gaskets.

Penetrating oil liberally sprayed on all bolts before removal eases the work.

Good luck!

Saabreur


Posted on Aug 09, 2009

  • 42818 Answers

SOURCE: 1999 honda misfire #1 cylinder no 300 code so many things. Change all new ... Egr... Injectors....o2 sensors. Both bank 1 and 2....... Catalictic convertor.... Spark plugs..and wires......this car d

have a compression test done to check for valve or loose valve seat insert.

Posted on Mar 14, 2015

  • 32 Answers

SOURCE: How many gallon water coolant/antifreeze capacity for 2014 Toyota Yaris. Thank you Sir/Madam. God bless you all

6.7 quarts

Posted on Mar 19, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hello, how can I resolve an error code B0001 for a 2004 Isuzu Ascender with a 4.2L engine? Thank you!


There are no results for this error, scan and see if a different error pops up. You can go to any auto parts store to get it scanned as long as the check engine light is on. Advanced Auto etc, Auto zone. God Bless! Its free!

Nov 23, 2016 | 2004 Isuzu Ascender

1 Answer

Anyone have problems with the Mac 2400 air compressor leaking oil.


Sounds like your threads are stripped or the plug is the wrong one.

I'd try some teflon tape several turns, after you remove it and verify the threads match and are not stripped.

Although rare, there is such a thing as the tank being cracked, as well, at the drain hole.

For most applications, there are "oversize" screw plugs available at some car parts stores.

God bless your efforts.

Mar 07, 2016 | Cars & Trucks

1 Answer

What year windshields will interchange with a 96 Chevy s10


1994-2002 should give you a broad range of years to look for. There may be some even newer models than that that are compatible but definitely not before 1994. Thank you and God bless you.

A thumbs up would be greatly appreciated if answer is helpful for your question. THANK you and GOD BLESS

Nov 22, 2014 | Cars & Trucks

1 Answer

SDN relay ticking check engine cames and goes, car some times start but it shut down soon, I change fuel pump and fuel filter alreadynow i think may problem is electrical any ideas, thank you


1) Reset the ignition timing, according the specification manufacturere VERY important.
2) Reset the Gap from spark plug, according the s. Manufacturer Very I.
3) See the diagrams attached, and proceed according.
God bless you

May 21, 2012 | 1998 Dodge Grand Caravan

2 Answers

Power window fuse location for 2001 mustang


There is a 20 amp circuit breaker located in the fuse box in the inside of your vehicle. It's in the number 43 position (see picture below). I hope this helps you and good luck.


clifford224_143.gif

Apr 13, 2011 | Ford Mustang Cars & Trucks

1 Answer

**NEW** (End of paragraph) 2005 DODGE Problem with the Dodge Stratus Cars & Trucks **NEW** (End of paragraph) 2005 DODGE STRATUS 2.4L DOHC -X (problem-check engine light...


Almost sounds like a possible valve spring problem, That is sending out harmonics to the computer to activate the rev limiter. good luck

Jan 12, 2011 | Dodge Stratus Cars & Trucks

1 Answer

**NEW** (End of paragraph) 2005 DODGE STRATUS 2.4L DOHC -X (problem-check engine light on-code:P0016-camshaft/crankshaft sensor) WHAT HAPPENED: TIMING BELT BROKE WHILE DRIVING UNDER 35 MPH. HAD A CHEAP...


Well what i know is when the timing belt breaks the Valves get bent for most of the time like 99% And i don't know if that Mechanic checked the valves or not because if they are bent then the valves wont close properly as it should and the car wont have power and the RPM will be low even if you accelerate. and what i can say is take your car to an autopart store Like Pep boys or autozone, and ask them to scan it and erase the code and see if it back again and they should scan it for free. Good luck

Jan 12, 2011 | Dodge Stratus Cars & Trucks

1 Answer

Check engine light on 97 honda odyssey code 171?


Hi, the egg smell is an early sign of bad valve timing and bad seals as well. the engine light normally, will signal a change for a specific sensor like a O2 sensor or egr valve or pcv malfunction.


Please rate this response, thank you and god bless.

Mar 16, 2009 | 1997 Honda Odyssey

1 Answer

Air conditioning on a 2000 chevy impala


Yes it could be the selector switch or a jammed diverter door.Good Luck!!! God Bless You As Well...

Aug 04, 2008 | 2003 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...