Question about Nissan Cars & Trucks

1 Answer

Do the engine suppose to cut off when i disconnect the air flow sensor on a 1989 nissan pickup truck?

The engine run rough black smoke coming from tail pipe.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Nissan Master
  • 1,062 Answers

It should

Posted on May 17, 2017

  • Joe Russell May 18, 2017

    the engine do not cut off when i disconnect the wire fron the air flow sensor do that mean the sensor is bad?

  • Joe Russell May 19, 2017

    the engine do not cut off when i disconnect the wire fron the air flow sensor do that mean the sensor is bad? do i have to replace the throttle body alone with the air flow sensor? the sensor is mount on the side of the throttle.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i read the codes on a 1989 nissan D21 pickup truck?


black smoke indicates oil getting into the cylinders , get the compressions tested as a first step

Jun 11, 2017 | Nissan Cars & Trucks

1 Answer

Engine run rough and black smoke coming from tail pipe why?


Go to the wreckers car junk yard and see if you can find another module or buy a new one but yes it sounds faulty... modules are non-serviceable so just get another... Run a code reader just to make sure that it is that module thats faulty

May 09, 2017 | Cars & Trucks

3 Answers

2003 Nissan Altima 2.5L Service Engine Soon Light is on, Auto Zone says codes are for MAF and O2 Sensors. Car hard to start after driving a while but when starts appears to run smooth. Auto Zone thi


ok lets start with the codes they say your getting. P??? which 1's and how many. there are few o2 sensors, are they next to the Exhaust next to the converter? MASS AIR FLOW -MAF use this, for now i am guessing, until i see the correct codes your are getting. this could be the 1 you may have below, please read it........
  • P0103
    Mass Air Flow Sensor Circuit High Input
  • Possible causes
  • Faulty mass air flow sensor
    - Intake air leaks
    - Dirty mass air flow sensor
    - Dirty mass air filter
    - Mass air flow sensor harness is open or shorted
    - Mass air flow sensor circuit poor electrical connection
  • Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
  • possible symptoms Engine Light ON (or Service Engine Soon Warning Light)
    - Engine stall
    - Engine running rough
    - Excessive fuel consumption
    - Excessive smoke
  • the code is generated when An excessively high voltage from the sensor is sent to Engine Control Module (ECM).
2003 NISSAN Altima Sedan OBDII Codes List

Oct 22, 2014 | 2003 Nissan Altima

1 Answer

Idles fine cuts out at 2500rpms will not get past 2500rpms


The mass air flow sensor, on passenger side of throttle body, if that is disconnected or faulty, the engine will cut out at 2500rpm. And act like its bouncing off the rev limiter.

Oct 23, 2010 | 1997 Nissan Pickup

1 Answer

Nissan truck idles fine, does not acelerate well, and misses


Try to disconnect MAF sensor(mass air flow sensor) or MAP sensor (manifold absolute pressure) , I don't know which one you have , (suppose to have either one) , when engine running and see if it becomes any better , if it did , then it's your problem.
Just remember one thing , if your check engine light is off now , it will be on after you disconnect any above mentioned components.
Easy to reset , disconnect battery for 30 sec.

May 27, 2010 | 1995 Nissan Pickup

1 Answer

Black smoke from exhaust,no idle in warm temps-97 Nissan 2WD 2.4L


I had a 1995 nissan pick up with a similar problem, may want to try cleaning out or replacing the EGR valve.

Jul 23, 2009 | 1997 Nissan Pickup

1 Answer

1997 Nissan hard body pick-up 2.4 won't idle and blows smoke


it soubds like you have a vacum leak problem listen for a "his" with the engine running. you may want to take apiece of hose @2-3ft long put one end at you ear and probe arround the top of the engine arrount the intake manafold and any hoses when you find the his find wher it goes and replace repair the hose. it may also be your pcvvalve thst is stuck it willcome out of the top of your valve cover and plug right the intake hose right before the throttle body

Jul 21, 2009 | 1989 Nissan Hardbody King

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...